HD6417615AF60 HITACHI [Hitachi Semiconductor], HD6417615AF60 Datasheet - Page 552

• Manufacturer Part Number: HD6417615AF60
• Description: CMOS single-chip microcontroller
• Manufacturer: HITACHI [Hitachi Semiconductor]

a reset signal from the RES pin, but is not initialized by the internal reset signal generated by
overflow of the WDT. It is initialized to H'1F in standby mode, when the clock frequency is
changed, and in clock pause mode.
Bit 7—Watchdog Timer Overflow Flag (WOVF): Indicates that WTCNT has overflowed (from
H'FF to H'00) in watchdog timer mode. It is not set in interval timer mode.
Bit 7: WOVF
0
1
Bit 6—Reset Enable (RSTE): Selects whether to reset the chip internally if WTCNT overflows in
watchdog timer mode.
Bit 6: RSTE
0
1
Bit 5—Reset Select (RSTS): Selects the type of internal reset generated if WTCNT overflows in
watchdog timer mode.
Bit 5: RSTS
0
1
Bits 4 to 0—Reserved: These bits are always read as 1. The write value should always be 1.
13.2.4
The watchdog timer’s WTCNT, WTCSR, and RSTCSR registers differ from other registers in that
they are more difficult to write. The procedures for writing and reading these registers are given
below.
Writing to WTCNT and WTCSR: These registers must be written by a word transfer
instruction. They cannot be written by byte or longword transfer instructions. WTCNT and
WTCSR both have the same write address. The write data must be contained in the lower byte of
the written word. The upper byte must be H'5A (for WTCNT) or H'A5 (for WTCSR) (figure 13.2).
This transfers the write data from the lower byte to WTCNT or WTCSR.
538
Notes on Register Access
Description
No WTCNT overflow in watchdog timer mode
Cleared by reading WOVF, then writing 0 in WOVF
Set by WTCNT overflow in watchdog timer mode
Description
Not reset when WTCNT overflows
LSI not reset internally, but WTCNT and WTCSR reset within WDT
Reset when WTCNT overflows
Description
Power-on reset
Manual reset
(Initial value)
(Initial value)
(Initial value)