HD6433044 Hitachi Semiconductor, HD6433044 Datasheet - Page 149

• Manufacturer Part Number: HD6433044
• Description: (HD64 Series) Hitachi Single-Chip Microcomputer
• Manufacturer: Hitachi Semiconductor

Wait Modes in Areas Where Wait-State Controller is Enabled
External three-state access areas in which the wait-state controller is enabled (ASTn = 1, WCEn =
1) can operate in pin wait mode 1, pin auto-wait mode, or programmable wait mode, as selected
by bits WMS1 and WMS0. Bits WMS1 and WMS0 apply to all areas, so all areas in which the
wait-state controller is enabled operate in the same wait mode.
Pin Wait Mode 1: In all accesses to external three-state-access areas, the number of wait states
(T
clock (ø) in the last of these wait states, an additional wait state is inserted. If the WAIT pin
remains low, wait states continue to be inserted until the WAIT signal goes high.
Pin wait mode 1 is useful for inserting four or more wait states, or for inserting different numbers
of wait states for different external devices.
If the wait count is 0, this mode operates in the same way as pin wait mode 0.
Figure 6-13 shows the timing when the wait count is 1 (WC1 = 0, WC0 = 1) and one additional
wait state is inserted by WAIT input.
W
Read
access
Write
access
Note:
) selected by bits WC1 and WC0 are inserted. If the WAIT pin is low at the fall of the system
*
Arrows indicate time of sampling of the
ø
WAIT
Address bus
AS
RD
Data bus
HWR, LWR
Data bus
pin
T
1
Figure 6-13 Pin Wait Mode 1
T
WAIT
2
135
pin.
External address
Inserted by
wait count
Write data
Write data
T
W
*
Inserted by
WAIT
T
W
signal
*
Read data
T
3