HD6433044 Hitachi Semiconductor, HD6433044 Datasheet - Page 482

• Manufacturer Part Number: HD6433044
• Description: (HD64 Series) Hitachi Single-Chip Microcomputer
• Manufacturer: Hitachi Semiconductor

In transmitting serial data, the SCI operates as follows.
•
•
•
Figure 13-6 shows an example of SCI transmit operation in asynchronous mode.
TDRE
TEND
The SCI monitors the TDRE flag in SSR. When the TDRE flag is cleared to 0 the SCI
recognizes that TDR contains new data, and loads this data from TDR into TSR.
After loading the data from TDR into TSR, the SCI sets the TDRE flag to 1 and starts
transmitting. If the TIE bit is set to 1 in SCR, the SCI requests a transmit-data-empty interrupt
(TXI) at this time.
Serial transmit data is transmitted in the following order from the TxD pin:
— Start bit:
— Transmit data:
— Parity bit or multiprocessor bit: One parity bit (even or odd parity) or one multiprocessor
— Stop bit:
— Mark state:
The SCI checks the TDRE flag when it outputs the stop bit. If the TDRE flag is 0, the SCI
loads new data from TDR into TSR, outputs the stop bit, then begins serial transmission of
the next frame. If the TDRE flag is 1, the SCI sets the TEND flag to 1 in SSR, outputs the
stop bit, then continues output of 1 bits in the mark state. If the TEIE bit is set to 1 in SCR, a
transmit-end interrupt (TEI) is requested at this time.
Figure 13-6 Example of SCI Transmit Operation in Asynchronous Mode
1
TXI
interrupt
request
Start
bit
0
TXI interrupt handler
writes data in TDR and
clears TDRE flag to 0
D0
(8-Bit Data with Parity and 1 Stop Bit)
D1
1 frame
Data
D7
Parity
bit
One 0 bit is output.
7 or 8 bits are output, LSB first.
bit is output. Formats in which neither a parity bit nor a
multiprocessor bit is output can also be selected.
One or two 1 bits (stop bits) are output.
Output of 1 bits continues until the start bit of the next
transmit data.
0/1
Stop
bit
TXI
interrupt
request
1
471
Start
bit
0
D0
D1
Data
D7
TEI interrupt request
Parity
bit
0/1
Stop
bit
1
Idle (mark)
state
1