MT29F8G08FACWP:C TR Micron Technology Inc, MT29F8G08FACWP:C TR Datasheet - Page 35

• Manufacturer Part Number: MT29F8G08FACWP:C TR
• Description: IC FLASH 8GBIT 48TSOP
• Manufacturer: Micron Technology Inc

Specifications of MT29F8G08FACWP:C TR

• Format - Memory: FLASH
• Memory Type: FLASH - Nand
• Memory Size: 8G (1G x 8)
• Interface: Parallel
• Voltage - Supply: 2.7 V ~ 3.6 V
• Operating Temperature: 0°C ~ 70°C
• Package / Case: 48-TSOP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Speed: -

OTP DATA READ AFh-30h
Figure 27:
PDF: 09005aef814b01a2 / Source: 09005aef814b01c7
2_4_8gb_nand_m49a__2.fm - Rev. D 12/06 EN
WE#
R/B#
I/Ox
ALE
CLE
CE#
RE#
OTP DATA READ
AFh
Notes: 1. The OTP page must be within the 02h–0Bh range.
add 1
Col
The OTP DATA READ (AFh-30h) command is used to read data from a page within the
OTP area. An OTP page within the OTP area is available for reading data whether or not
the area is protected.
To use the OTP DATA READ command, issue the AFh command. Then issue 5 ADDRESS
cycles: the first 2 ADDRESS cycles are the column address, and for the remaining 3
cycles select a page in the range of 02h-00h-00h through 0Bh-00h-00h. Finally, issue the
30h command.
R/B# goes LOW (
READ STATUS (70h) command and the RESET (FFh) command are the only commands
valid during the OTP DATA READ operation. Bit 5 of the status register will reflect the
state of R/B#. For details, refer to Table 11 on page 26.
Normal READ operation timings apply to OTP read accesses (see Figure 27). Additional
pages within the OTP area can be selected by repeating the OTP DATA READ command.
add 2
Col
page
OTP
t
1
R) while the data is moved from the OTP page to the data register. The
00h
00h
35
2Gb, 4Gb, 8Gb: x8, x16 NAND Flash Memory
30h
Micron Technology, Inc., reserves the right to change products or specifications without notice.
Busy
t R
D
OUT
N
Command Definitions
N + 1
D
OUT
©2005 Micron Technology, Inc. All rights reserved.
Don’t Care
D
M
OUT