AT32UC3B0512-A2UT Atmel, AT32UC3B0512-A2UT Datasheet - Page 486

• Manufacturer Part Number: AT32UC3B0512-A2UT
• Description: IC MCU AVR32 512K FLASH 64TQFP
• Manufacturer: Atmel
• Series: AVR®32 UC3r

Specifications of AT32UC3B0512-A2UT

• Core Processor: AVR
• Core Size: 32-Bit
• Speed: 60MHz
• Connectivity: I²C, IrDA, SPI, SSC, UART/USART, USB
• Peripherals: Brown-out Detect/Reset, DMA, POR, PWM, WDT
• Number Of I /o: 44
• Program Memory Size: 512KB (512K x 8)
• Program Memory Type: FLASH
• Ram Size: 96K x 8
• Voltage - Supply (vcc/vdd): 1.65 V ~ 1.95 V
• Data Converters: A/D 8x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 64-TQFP, 64-VQFP
• Controller Family/series: AT32UC3B
• No. Of I/o's: 44
• Ram Memory Size: 96KB
• Cpu Speed: 60MHz
• No. Of Timers: 1
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

23.6.1.5
32059K–03/2011
TC operating modes
Figure 23-3. Clock Control
Each channel can independently operate in two different modes:
The TC operating mode selection is done by writing to the Wave bit in the CCRn register
(CCRn.WAVE).
In Capture mode, TIOA and TIOB are configured as inputs.
In Waveform mode, TIOA is always configured to be an output and TIOB is an output if it is not
selected to be the external trigger.
• The clock can be enabled or disabled by the user by writing to the Counter Clock
• The clock can also be started or stopped: a trigger (software, synchro, external or compare)
• Capture mode provides measurement on signals.
• Waveform mode provides wave generation.
Enable/Disable Command bits in the Channel n Clock Control Register (CCRn.CLKEN and
CCRn.CLKDIS). In Capture mode it can be disabled by an RB load event if the Counter Clock
Disable with RB Loading bit in CMRn is written to one (CMRn.LDBDIS). In Waveform mode,
it can be disabled by an RC Compare event if the Counter Clock Disable with RC Compare
bit in CMRn is written to one (CMRn.CPCDIS). When disabled, the start or the stop actions
have no effect: only a CLKEN command in CCRn can re-enable the clock. When the clock is
enabled, the Clock Enabling Status bit is set in SRn (SRn.CLKSTA).
always starts the clock. In Capture mode the clock can be stopped by an RB load event if the
Counter Clock Stopped with RB Loading bit in CMRn is written to one (CMRn.LDBSTOP). In
Waveform mode it can be stopped by an RC compare event if the Counter Clock Stopped
with RC Compare bit in CMRn is written to one (CMRn.CPCSTOP). The start and the stop
commands have effect only if the clock is enabled.
Selected
Clock
Counter
Clock
Q
S
R
Trigger
CLKSTA
Q
CLKEN
S
R
Event
Stop
CLKDIS
AT32UC3B
Disable
Event
486