DF2148ATE20 Renesas Electronics America, DF2148ATE20 Datasheet - Page 345

• Manufacturer Part Number: DF2148ATE20
• Description: IC H8S MCU FLASH 128K 100-QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2100r

Specifications of DF2148ATE20

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 20MHz
• Connectivity: Host Interface, I²C, IrDA, SCI
• Peripherals: POR, PWM, WDT
• Number Of I /o: 74
• Program Memory Size: 128KB (128K x 8)
• Program Memory Type: FLASH
• Ram Size: 4K x 8
• Voltage - Supply (vcc/vdd): 4 V ~ 5.5 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 100-TQFP, 100-VQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -
• Other names: HD64F2148ATE20; HD64F2148ATE20

10.3
DACNT, DADRA, and DADRB are 16-bit registers. The data bus linking the bus master and the
on-chip supporting modules, however, is only 8 bits wide. When the bus master accesses these
registers, it therefore uses an 8-bit temporary register (TEMP).
These registers are written and read as follows (taking the example of the CPU interface).
These registers should always be accessed 16 bits at a time using an MOV instruction (by word
access or two consecutive byte accesses), and the upper byte should always be accessed before the
lower byte. Correct data will not be transferred if only the upper byte or only the lower byte is
accessed. Also note that a bit-manipulation instruction cannot be used to access these registers.
Figure 10.2 shows the data flow for access to DACNT. The other registers are accessed similarly.
Example 1: Write to DACNT
Example 2: Read DADRA
MOV.W R0, @DACNT
MOV.W @DADRA, R0
Write
When the upper byte is written, the upper-byte write data is stored in TEMP. Next, when the
lower byte is written, the lower-byte write data and TEMP value are combined, and the
combined 16-bit value is written in the register.
Read
When the upper byte is read, the upper-byte value is transferred to the CPU and the lower-byte
value is transferred to TEMP. Next, when the lower byte is read, the lower-byte value in
TEMP is transferred to the CPU.
Bus Master Interface
; Write R0 contents to DACNT
; Transfer contents of DADRA to R0
Rev. 4.00 Sep 27, 2006 page 299 of 1130
Section 10 14-Bit PWM Timer (PWMX)
REJ09B0327-0400