R88A-CNG01R Omron, R88A-CNG01R Datasheet - Page 240

• Manufacturer Part Number: R88A-CNG01R
• Description: Encoder Connector ABS Motor
• Manufacturer: Omron

Specifications of R88A-CNG01R

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

4
4-1 Installation Conditions
Decelerators
4-7
Installing Decelerators
Installing an R88G-HPG@@@ (Backlash = 3’ Max.)
1. Turn the input joint and align the head of the bolt that secures the shaft with the
2. Apply sealant to the installation surface on the Servomotor (recommended sealant:
3. Gently insert the Servomotor into the Decelerator.
4. Bolt together the Servomotor and the Decelerator flanges.
5. Tighten the input joint bolt.
6. Mount the supplied rubber cap to complete the installation procedure.
rubber cap.
Loctite 515).
Use the following procedure to install the Decelerator on the Servomotor.
As shown in the figures on the next page, stand the Decelerator upright and slide the Servomotor
shaft into the input shaft joint while making sure it does not fall over. If the Decelerator cannot be
stood upright, tighten each bolt evenly little by little to ensure that the Servomotor is not inserted at
a tilt.
Bolt Tightening Torque for Aluminum
Bolt Tightening Torque for Duralumin
Note Always use the torque given in the table above. The Servomotor may slip or other problems
The R88G-HPG11@ uses two set screws for the connecting section.
(For the R88G-HPG11@, mount two screws with gaskets.)
Allen head bolt size
Tightening torque (N·m)
Allen head bolt size
Tightening torque (N·m)
Allen head bolt size
Tightening torque (N·m)
may occur if the specified torque level is not satisfied.
M4
3.2
M4
2.0
0.69
M3
M5
6.3
M5
4.5
15.3
10.7
M6
M6
37.2
26.1
M8
M8
M10
73.5
M10
51.5
M12
M12
89.9
128