ATmega1280 Atmel Corporation, ATmega1280 Datasheet - Page 184

• Manufacturer Part Number: ATmega1280
• Manufacturer: Atmel Corporation

Specifications of ATmega1280

• Flash (kbytes): 128 Kbytes
• Pin Count: 100
• Max. Operating Frequency: 16 MHz
• Cpu: 8-bit AVR
• # Of Touch Channels: 16
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 86
• Ext Interrupts: 32
• Usb Speed: No
• Usb Interface: No
• Spi: 5
• Twi (i2c): 1
• Uart: 4
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 16
• Adc Resolution (bits): 10
• Adc Speed (ksps): 15
• Analog Comparators: 1
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 8
• Eeprom (bytes): 4096
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8 to 5.5
• Operating Voltage (vcc): 1.8 to 5.5
• Fpu: No
• Mpu / Mmu: no / no
• Timers: 6
• Output Compare Channels: 16
• Input Capture Channels: 4
• Pwm Channels: 15
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

20.8
2549N–AVR–05/11
Asynchronous Operation of Timer/Counter2
Figure 20-10
Figure 20-10. Timer/Counter Timing Diagram, Setting of OCF2A, with Prescaler (f
Figure 20-11
Figure 20-11. Timer/Counter Timing Diagram, Clear Timer on Compare Match mode, with Pres-
When Timer/Counter2 operates asynchronously, some considerations must be taken.
•
Warning: When switching between asynchronous and synchronous clocking of
Timer/Counter2, the Timer Registers TCNT2, OCR2x, and TCCR2x might be corrupted. A
safe procedure for switching clock source is:
1. Disable the Timer/Counter2 interrupts by clearing OCIE2x and TOIE2.
2. Select clock source by setting AS2 as appropriate.
3. Write new values to TCNT2, OCR2x, and TCCR2x.
4. To switch to asynchronous operation: Wait for TCN2UB, OCR2xUB, and TCR2xUB.
5. Clear the Timer/Counter2 Interrupt Flags.
6. Enable interrupts, if needed.
TCNTn
TCNTn
(clk
(clk
OCRnx
(CTC)
OCRnx
OCFnx
OCFnx
clk
clk
clk
clk
I/O
I/O
I/O
I/O
Tn
Tn
/8)
/8)
shows the setting of OCF2A in all modes except CTC mode.
shows the setting of OCF2A and the clearing of TCNT2 in CTC mode.
caler (f
clk_I/O
OCRnx - 1
TOP - 1
/8)
ATmega640/1280/1281/2560/2561
TOP
OCRnx
OCRnx Value
TOP
BOTTOM
OCRnx + 1
BOTTOM + 1
OCRnx + 2
clk_I/O
/8)
184