PIC18F2480 MICROCHIP [Microchip Technology], PIC18F2480 Datasheet - Page 201

• Manufacturer Part Number: PIC18F2480
• Description: 28/40/44-Pin Enhanced Flash Microcontrollers with ECAN Technology, 10-Bit A/D and nanoWatt Technology
• Manufacturer: MICROCHIP [Microchip Technology]

REGISTER 17-5:
 2004 Microchip Technology Inc.
bit 7
bit 6
bit 5
bit 4
bit 3
bit 2
bit 1
bit 0
SSPCON2: MSSP CONTROL REGISTER 2 (I
bit 7
GCEN: General Call Enable bit (Slave mode only)
1 = Enable interrupt when a general call address (0000h) is received in the SSPSR
0 = General call address disabled
ACKSTAT: Acknowledge Status bit (Master Transmit mode only)
1 = Acknowledge was not received from slave
0 = Acknowledge was received from slave
ACKDT: Acknowledge Data bit (Master Receive mode only)
1 = Not Acknowledge
0 = Acknowledge
ACKEN: Acknowledge Sequence Enable bit (Master Receive mode only)
1 = Initiate Acknowledge sequence on SDA and SCL pins and transmit ACKDT data bit.
0 = Acknowledge sequence Idle
RCEN: Receive Enable bit (Master mode only)
1 = Enables Receive mode for I
0 = Receive Idle
PEN: Stop Condition Enable bit (Master mode only)
1 = Initiate Stop condition on SDA and SCL pins. Automatically cleared by hardware.
0 = Stop condition Idle
RSEN: Repeated Start Condition Enable bit (Master mode only)
1 = Initiate Repeated Start condition on SDA and SCL pins. Automatically cleared by hardware.
0 = Repeated Start condition Idle
SEN: Start Condition Enable/Stretch Enable bit
In Master mode:
1 = Initiate Start condition on SDA and SCL pins. Automatically cleared by hardware.
0 = Start condition Idle
In Slave mode:
1 = Clock stretching is enabled for both slave transmit and slave receive (stretch enabled)
0 = Clock stretching is disabled
Legend:
R = Readable bit
-n = Value at POR
GCEN
R/W-0
Note:
Note 1: For bits ACKEN, RCEN, PEN, RSEN, SEN: If the I
Automatically cleared by hardware.
Value that will be transmitted when the user initiates an Acknowledge sequence at
the end of a receive.
these bits may not be set (no spooling) and the SSPBUF may not be written (or
writes to the SSPBUF are disabled).
ACKSTAT
R/W-0
PIC18F2480/2580/4480/4580
ACKDT
R/W-0
Preliminary
W = Writable bit
‘1’ = Bit is set
2
C
ACKEN
R/W-0
(1)
(1)
(1)
U = Unimplemented bit, read as ‘0’
‘0’ = Bit is cleared
RCEN
2
(1)
R/W-0
C™ MODE)
(1)
2
C module is not in the Idle mode,
PEN
R/W-0
(1)
(1)
RSEN
x = Bit is unknown
(1)
R/W-0
DS39637A-page 199
(1)
SEN
R/W-0
bit 0
(1)