MC68HC912BD32CFU10 FREESCALE [Freescale Semiconductor, Inc], MC68HC912BD32CFU10 Datasheet - Page 86

• Manufacturer Part Number: MC68HC912BD32CFU10
• Description: Advance Information
• Manufacturer: FREESCALE [Freescale Semiconductor, Inc]

EEPROM Programmer’s Model
EEPROM
MC68HC912BD32 Rev 1.0
The EEPROM module consists of two separately addressable sections.
The first is a four-byte memory mapped control register block used for
control, testing and configuration of the EEPROM array. The second
section is the EEPROM array itself.
At reset, the four-byte register section starts at address $00F0 and the
EEPROM array is located from addresses $0D00 to $0FFF. For
information on re-mapping the register block and EEPROM address
space, refer to
Read/write access to the memory array section can be enabled or
disabled by the EEON control bit in the INITEE register. This feature
allows the access of memory mapped resources that have lower priority
than the EEPROM memory array. EEPROM control registers can be
accessed and EEPROM locations may be programmed or erased
regardless of the state of EEON.
Using the normal EEPROG control, it is possible to continue
program/erase operations during WAIT. For lowest power consumption
during WAIT, stop program/erase by turning off EEPGM.
If the STOP mode is entered during programming or erasing,
program/erase voltage will be automatically turned off and the RC clock
(if enabled) is stopped. However, the EEPGM control bit will remain set.
When STOP mode is terminated, the program/erase voltage will be
automatically turned back on if EEPGM is set.
At low bus frequencies, the RC clock must be turned on for
program/erase.
The EEPROM module contains an extra byte called SHADOW byte
which is loaded at reset into the EEMCR register.
To program the SHADOW byte, when in special modes (SMODN=0),
the NOSHB bit in EEMCR register must be cleared. Normal
programming routines are used to program the SHADOW byte which
becomes accessible at address $0FC0 when NOSHB is cleared.
At the next reset the SHADOW byte data is loaded into the EEMCR.
Freescale Semiconductor, Inc.
For More Information On This Product,
Go to: www.freescale.com
Operating
EEPROM
Modes.
2-eeprom