AT32UC3C2256C Atmel Corporation, AT32UC3C2256C Datasheet - Page 454

• Manufacturer Part Number: AT32UC3C2256C
• Manufacturer: Atmel Corporation

Specifications of AT32UC3C2256C

• Flash (kbytes): 256 Kbytes
• Pin Count: 64
• Max. Operating Frequency: 66 MHz
• Cpu: 32-bit AVR
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 45
• Ext Interrupts: 64
• Usb Transceiver: 1
• Quadrature Decoder Channels: 1
• Usb Speed: Full Speed
• Usb Interface: Device + OTG
• Spi: 5
• Twi (i2c): 2
• Uart: 4
• Can: 2
• Lin: 4
• Ssc: 1
• Ethernet: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 11
• Adc Resolution (bits): 12
• Adc Speed (ksps): 2000
• Analog Comparators: 2
• Resistive Touch Screen: No
• Dac Channels: 2
• Dac Resolution (bits): 12
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 68
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 3.0 to 3.6 or 4.5 to 5.5
• Operating Voltage (vcc): 3.0 to 3.6 or 4.5 to 5.5
• Fpu: Yes
• Mpu / Mmu: Yes / No
• Timers: 3
• Output Compare Channels: 13
• Input Capture Channels: 6
• Pwm Channels: 14
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

23.4
23.5
23.5.1
23.5.2
23.5.3
23.5.4
32117C–AVR-08/11
Pin Name
GPIOn
I/O Lines Description
Product Dependencies
Power Management
Clocks
Interrupts
Debug Operation
In order to use this module, other parts of the system must be configured correctly, as described
below.
If the CPU enters a sleep mode that disables clocks used by the GPIO, the GPIO will stop func-
tioning and resume operation after the system wakes up from sleep mode.
If a peripheral function is configured for a GPIO pin, the peripheral will be able to control the
GPIO pin even if the GPIO clock is stopped.
The GPIO is connected to a Peripheral Bus clock (CLK_GPIO). This clock is generated by the
Power Manager. CLK_GPIO is enabled at reset, and can be disabled by writing to the Power
Manager. CLK_GPIO must be enabled in order to access the configuration registers of the GPIO
or to use the GPIO interrupts. After configuring the GPIO, the CLK_GPIO can be disabled by
writing to the Power Manager if interrupts are not used.
If the CPU Local Bus is used to access the configuration interface of the GPIO, the CLK_GPIO
must be equal to the CPU clock to avoid data loss.
The GPIO interrupt request lines are connected to the interrupt controller. Using the GPIO inter-
rupts requires the interrupt controller to be programmed first.
When an external debugger forces the CPU into debug mode, the GPIO continues normal oper-
ation. If the GPIO is configured in a way that requires it to be periodically serviced by the CPU
through interrupts or similar, improper operation or data loss may result during debugging.
Description
GPIO pin n
Type
Digital
AT32UC3C
454