SAM9RL64 Atmel Corporation, SAM9RL64 Datasheet - Page 86

• Manufacturer Part Number: SAM9RL64
• Manufacturer: Atmel Corporation

Specifications of SAM9RL64

• Flash (kbytes): 0 Kbytes
• Pin Count: 217
• Max. Operating Frequency: 240 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 118
• Ext Interrupts: 118
• Usb Transceiver: 1
• Usb Speed: Hi-Speed
• Usb Interface: Device
• Spi: 1
• Twi (i2c): 2
• Uart: 5
• Ssc: 2
• Sd / Emmc: 1
• Graphic Lcd: Yes
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 6
• Adc Resolution (bits): 10
• Adc Speed (ksps): 220
• Resistive Touch Screen: Yes
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 64
• Self Program Memory: NO
• External Bus Interface: 1
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 1.08 to 1.32
• Fpu: No
• Mpu / Mmu: No / Yes
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

Memory Interface
4.6.2
4-10
Instruction interface, sequential cycles
Sequential instruction fetches are used to perform burst transfers on the bus. This
information can be used to optimize the design of a memory controller interfacing to a
burst memory device, such as a DRAM.
During a sequential cycle, the ARM9E-S requests a memory location that is part of a
sequential burst. If this is the first cycle in the burst, the address might be the same as
the previous internal cycle. Otherwise the address is incremented from the previous
instruction fetch that was performed:
•
•
The types of bursts are shown in Table 4-7.
All accesses in a burst are of the same width, direction, and protection type. For more
details, see Instruction interface addressing signals on page 4-4.
Bursts of byte accesses are not possible with the instruction memory interface.
A burst always starts with an N cycle, or a merged I-S cycle (see Instruction interface,
merged I-S cycles on page 4-11), and continues with S cycles. A burst comprises
transfers of the same type or size. The IA[31:1] signal increments during the burst. The
other address class signals are unaffected by a burst.
An example of a burst access is shown in Figure 4-3 on page 4-11.
Burst type
Word read
Halfword read
for a burst of word accesses, the address is incremented by 4 bytes
for a burst of halfword access, the address is incremented by 2 bytes.
Copyright © 2000 ARM Limited. All rights reserved.
Address
increment
4 bytes
2 bytes
Cause
Thumb code fetches
ARM code fetches
Table 4-7 Burst types
ARM DDI 0165B