C8051F962-A-GM Silicon Labs, C8051F962-A-GM Datasheet - Page 130

• Manufacturer Part Number: C8051F962-A-GM
• Description: 8-bit Microcontrollers - MCU 128KB, DC-DC, AES DQFN76
• Manufacturer: Silicon Labs

Specifications of C8051F962-A-GM

• Rohs: yes
• Core: 8051
• Processor Series: C8051
• Data Bus Width: 8 bit
• Maximum Clock Frequency: 25 MHz
• Program Memory Size: 128 KB
• Data Ram Size: 8448 B
• On-chip Adc: Yes
• Operating Supply Voltage: 2.5 V to 3.3 V
• Operating Temperature Range: - 40 C to + 85 C
• Package / Case: DQFN-76
• Mounting Style: SMD/SMT
• Number Of Programmable I/os: 57
• Number Of Timers: 4

C8051F96x
10.2. Configuring the External Memory Interface
Configuring the External Memory Interface consists of five steps:
Each of these five steps is explained in detail in the following sections. The Port selection, Multiplexed
mode selection, and Mode bits are located in the EMI0CF register shown in SFR Definition .
10.3. Port Configuration
The External Memory Interface appears on Ports 3, 4, 5, and 6 when it is used for off-chip memory access.
The external memory interface and the LCD cannot be used simultaneously. When using EMIF, all pins on
Port 3-6 may only be used for EMIF purposes or as general purpose I/O. The EMIF pinout is shown in
Table 10.1 on page 131.
The External Memory Interface claims the associated Port pins for memory operations ONLY during the
execution of an off-chip MOVX instruction. Once the MOVX instruction has completed, control of the Port
pins reverts to the Port latches or to the Crossbar settings for those pins. See Section “27. Port Input/Out-
put” on page 351 for more information about the Crossbar and Port operation and configuration. The Port
latches should be explicitly configured to “park” the External Memory Interface pins in a dormant
state, most commonly by setting them to a logic 1.
During the execution of the MOVX instruction, the External Memory Interface will explicitly disable the driv-
ers on all Port pins that are acting as Inputs (Data[7:0] during a READ operation, for example). The Output
mode of the Port pins (whether the pin is configured as Open-Drain or Push-Pull) is unaffected by the
External Memory Interface operation, and remains controlled by the PnMDOUT registers. In most cases,
the output modes of all EMIF pins should be configured for push-pull mode.
The C8051F960/2/4/6/8 devices support both the multiplexed and non-multiplexed modes. Accessing off-
chip memory is not supported by the C8051F961/3/5/7/9 devices.
130
1. Configure the Output Modes of the associated port pins as either push-pull or open-drain (push-pull
2. Configure Port latches to “park” the EMIF pins in a dormant state (usually by setting them to logic 1).
3. Select Multiplexed mode or Non-multiplexed mode.
4. Select the memory mode (on-chip only, split mode without bank select, split mode with bank select,
5. Set up timing to interface with off-chip memory or peripherals.
is most common). The Input Mode of the associated port pins should be set to digital (reset value).
or off-chip only).
Rev. 0.5