ATMEGA16U2-MU Atmel, ATMEGA16U2-MU Datasheet - Page 231

• Manufacturer Part Number: ATMEGA16U2-MU
• Description: MCU AVR 16K FLASH USB 32-VQFN
• Manufacturer: Atmel
• Series: AVR® ATmegar

Specifications of ATMEGA16U2-MU

• Core Processor: AVR
• Core Size: 8-Bit
• Speed: 16MHz
• Connectivity: SPI, UART/USART, USB
• Peripherals: Brown-out Detect/Reset, POR, PWM, WDT
• Number Of I /o: 22
• Program Memory Size: 16KB (8K x 16)
• Program Memory Type: FLASH
• Eeprom Size: 512 x 8
• Ram Size: 512 x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 5.5 V
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 32-VQFN Exposed Pad, 32-HVQFN, 32-SQFN, 32-DHVQFN
• Core: AVR8
• Processor Series: ATMEGA16x
• Data Bus Width: 8 bit
• Maximum Clock Frequency: 16 MHz
• Data Ram Size: 1.25 KB
• Data Rom Size: 512 B
• Number Of Programmable I/os: 22
• Number Of Timers: 2
• Mounting Style: SMD/SMT
• Height: 0.95 mm
• Interface Type: SPI, UART
• Length: 5 mm
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 40 C
• Supply Voltage (max): 5.5 V
• Supply Voltage (min): 2.7 V
• Width: 5 mm
• For Use With: ATSTK600 - DEV KIT FOR AVR/AVR32ATSTK500 - PROGRAMMER AVR STARTER KIT
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Data Converters: -
• Lead Free Status / Rohs Status: Details

23.6.3
7799D–AVR–11/10
External Hardware conditions
is programmed, the Reset Vector will always point to the Boot Loader Reset and the fuse can
only be changed through the serial or parallel programming interface.
Table 23-4.
Note:
The Hardware Boot Enable Fuse (HWBE) can be programmed (See
special hardware conditions under reset, the bootloader execution is forced after reset.
Table 23-5.
Note:
When the HWBE fuse is enable the
pled during reset rising edge. When
will be set as the Boot Loader Reset address and the Boot Loader will be executed (See Figures
23-3).
BOOTRST
HWBE
1
0
1
0
1. “1” means unprogrammed, “0” means programmed
1. “1” means unprogrammed, “0” means programmed
Boot Reset Fuse
Hardware Boot Enable Fuse
Reset Address
Reset Vector = Application Reset (address 0x0000)
Reset Vector = Boot Loader Reset (see
Reset Address
PD7/HWB pin can not be used to force Boot Loader execution after reset
PD7/HWB pin is used during reset to force bootloader execution after reset
(1)
PD7
PD7
/HWB pin is ‘0’ during reset rising edge, the reset vector
/HWB pin is configured as input during reset and sam-
(1)
ATmega8U2/16U2/32U2
Table 23-8 on page
Table
239)
23-5) so that upon
231