UPD78F9200MA-CAC-A Renesas Electronics America, UPD78F9200MA-CAC-A Datasheet - Page 252

• Manufacturer Part Number: UPD78F9200MA-CAC-A
• Description: MCU 8BIT 1KB FLASH 128B RAM
• Manufacturer: Renesas Electronics America
• Series: 78K0S/Kx1+r

Specifications of UPD78F9200MA-CAC-A

• Package / Case: *
• Voltage - Supply (vcc/vdd): 2 V ~ 5.5 V
• Operating Temperature: -40°C ~ 85°C
• Speed: 10MHz
• Number Of I /o: 7
• Core Processor: 78K0S
• Program Memory Type: FLASH
• Ram Size: 128 x 8
• Program Memory Size: 1KB (1K x 8)
• Data Converters: A/D 4x10b
• Oscillator Type: Internal
• Peripherals: LVD, POR, PWM, WDT
• Core Size: 8-Bit
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Connectivity: -

<R>
<R>
16.8.6 Example of block erase operation in self programming mode
250
An example of the block erase operation in self programming mode is explained below.
<1> Set 03H (block erase) to the flash program command register (FLCMD).
<2> Set the block number to be erased, to flash address pointer H (FLAPH).
<3> Set flash address pointer L (FLAPL) to 00H.
<4> Write the same value as FLAPH to the flash address pointer H compare register (FLAPHC).
<5> Set the flash address pointer L compare register (FLAPLC) to 00H.
<6> Clear the flash status register (PFS).
<7> Write ACH to the watchdog timer enable register (WDTE) (clear and restart the watchdog timer counter)
<8> Execute the HALT instruction then start self programming. (Execute an instruction immediately after the
<9> Check if a self programming error has occurred using bit 1 (VCERR) and bit 2 (WEPRERR) of PFS
<10> If the number of times the erase command can be executed has not been exceeded, return to step <6> and
<11> Block erase processing is abnormally terminated.
<12> Block erase processing is normally terminated.
Notes 1. This setting is not required when the watchdog timer is not used.
HALT instruction if self programming has been executed.)
Abnormal → <10>
Normal
re-execute the command. If the number of times the erase command can be executed has been exceeded,
block erasure ends abnormally.
2. Separately check the WEPRERR bit to check for errors in executing the erase command on a write-
prohibited area.
→ <12>
CHAPTER 16 FLASH MEMORY
User’s Manual U18172EJ3V0UD
Note 2
.
Note 1
.