QB-MINI2-EE NEC, QB-MINI2-EE Datasheet - Page 166

• Manufacturer Part Number: QB-MINI2-EE
• Description: EMULATOR, PROGRAMMER, MINICUBE2
• Manufacturer: NEC
• Type: Debug Emulatorr

Specifications of QB-MINI2-EE

• Svhc: No SVHC (18-Jun-2010)
• Mcu Supported Families: MINICUBE2
• Silicon Family Name: V850, 78K0R, 78K0S
• Ic Product Type: On-Chip Debug Emulator
• Kit Contents: MINICUBE2, USB Cable, Target Cable, 78K0-OCD Board
• Features: On-Chip Debugging, Flash Memory Programming,

7.2 Self-Testing Procedure
166
(1) Preparation and installation of software
(2) Switch setting
(3) Connecting the USB cable
(4) Startup of MINICUBE2 diagnostic tool
The following software is required to perform self-testing.
software, refer to the setup manual supplied with MINICUBE2.
The mode select switch can be set to ″M1″ or ″M2″.
Set the power select switch to ″3″ or ″5″.
Connect MINICUBE2 to the host machine. Do not connect MINICUBE2 to the target system. The mode
LED glows white after connection.
Start the MINICUBE2 diagnostic tool.
If the MINICUBE2 diagnostic tool was installed when NEC Electronics software was installed, the diagnostic
tool is registered on the Start menu as follows.
•
For the operation after this step, refer to the user's manual for the MINICUBE2 diagnostic tool.
MINICUBE2
MINICUBE2
• MINICUBE2 diagnostic tool
• USB driver
″NEC Electronics″→″MINICUBE Utilities″→″Vx.xx (version)″
Figure 7-2. Connecting MINICUBE2 to Host Machine
CHAPTER 7
User’s Manual U18371EJ1V0UM
USB cable
USB cable
SELF-TESTING
For details on preparation and installation of
Host machine
Host machine