QB-MINI2-EE NEC, QB-MINI2-EE Datasheet - Page 168

• Manufacturer Part Number: QB-MINI2-EE
• Description: EMULATOR, PROGRAMMER, MINICUBE2
• Manufacturer: NEC
• Type: Debug Emulatorr

Specifications of QB-MINI2-EE

• Svhc: No SVHC (18-Jun-2010)
• Mcu Supported Families: MINICUBE2
• Silicon Family Name: V850, 78K0R, 78K0S
• Ic Product Type: On-Chip Debug Emulator
• Kit Contents: MINICUBE2, USB Cable, Target Cable, 78K0-OCD Board
• Features: On-Chip Debugging, Flash Memory Programming,

8.2 Firmware Update Procedure
168
(1) Preparation and installation of software
(2) Switch setting
(3) Connecting the USB cable
(4) Startup of MINICUBE2 diagnostic tool
The following software is required to update firmware. For details on preparation and installation of software,
refer to the setup manual supplied with MINICUBE2.
The mode select switch and power select switch may be set to any position.
Connect MINICUBE2 to the host machine. Do not connect MINICUBE2 to the target system. The mode
LED glows white after connection.
Start the MINICUBE2 diagnostic tool.
If the MINICUBE2 diagnostic tool was installed when NEC Electronics software was installed, the diagnostic
tool is registered on the Start menu as follows.
•
For the operation after this step, refer to the user's manual for the MINICUBE2 diagnostic tool.
MINICUBE2
MINICUBE2
• MINICUBE2 diagnostic tool
• USB driver
″NEC Electronics″→″MINICUBE Utilities″→″Vx.xx (version)″
Figure 8-2. Connecting MINICUBE2 to Host Machine
CHAPTER 8
User’s Manual U17866EJ2V0UM
USB cable
USB cable
FIRMWARE UPDATE
Host machine
Host machine