ATxmega64D3 Atmel Corporation, ATxmega64D3 Datasheet - Page 154

• Manufacturer Part Number: ATxmega64D3
• Manufacturer: Atmel Corporation

Specifications of ATxmega64D3

• Flash (kbytes): 64 Kbytes
• Pin Count: 64
• Max. Operating Frequency: 32 MHz
• Cpu: 8-bit AVR
• # Of Touch Channels: 16
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 50
• Ext Interrupts: 50
• Usb Speed: No
• Usb Interface: No
• Spi: 5
• Twi (i2c): 2
• Uart: 3
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 16
• Adc Resolution (bits): 12
• Adc Speed (ksps): 200
• Analog Comparators: 2
• Resistive Touch Screen: No
• Temp. Sensor: Yes
• Crypto Engine: No
• Sram (kbytes): 4
• Eeprom (bytes): 2048
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: Yes
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.6 to 3.6
• Operating Voltage (vcc): 1.6 to 3.6
• Fpu: No
• Mpu / Mmu: no / no
• Timers: 5
• Output Compare Channels: 18
• Input Capture Channels: 18
• Pwm Channels: 18
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

14.5
8210B–AVR–04/10
Pattern Generation
Figure 14-4. Dead Time Generator timing diagram
The pattern generator extension reuses the DTI registers to produce a synchronized bit pattern
on the port it is connected to. In addition, the waveform generator output from CC channel A
(CCA)) can be distributed to and override all the port pins. These features are primarily intended
for handling the commutation sequence in BLDC and Stepper Motor Applications.
Figure 14-5. Pattern Generator block diagram
A block diagram of the pattern generator is shown in
where the corresponding OOE bit is set the multiplexer will output the waveform from CCA.
As for all other types of the Timer/Counter double-buffered registers the register update is syn-
chronized to the UPDATE condition set by the waveform generation mode. If the
synchronization provided is not required by the application, the application code can simply
access the DTIOE and PORTx registers directly.
The pins direction must be set for any output from the pattern generator to be visible on the port.
"WG output"
"dtls"
"dths"
"dti_cnt"
UPDATE
V
EN
DTIOE[7:0]
DTIBLS
t
DTILS
t
P
Timer/Counter 0 (TCx0)
V
EN
t
T
DTIHS
Figure 14-5 on page
PORTx[7:0]
DTIBHS
Px[7:0]
154. For each port pin
CCA WG output
XMEGA D
Expand
1 to 8
154