ATxmega64D3 Atmel Corporation, ATxmega64D3 Datasheet - Page 225

• Manufacturer Part Number: ATxmega64D3
• Manufacturer: Atmel Corporation

Specifications of ATxmega64D3

• Flash (kbytes): 64 Kbytes
• Pin Count: 64
• Max. Operating Frequency: 32 MHz
• Cpu: 8-bit AVR
• # Of Touch Channels: 16
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 50
• Ext Interrupts: 50
• Usb Speed: No
• Usb Interface: No
• Spi: 5
• Twi (i2c): 2
• Uart: 3
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 16
• Adc Resolution (bits): 12
• Adc Speed (ksps): 200
• Analog Comparators: 2
• Resistive Touch Screen: No
• Temp. Sensor: Yes
• Crypto Engine: No
• Sram (kbytes): 4
• Eeprom (bytes): 2048
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: Yes
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.6 to 3.6
• Operating Voltage (vcc): 1.6 to 3.6
• Fpu: No
• Mpu / Mmu: no / no
• Timers: 5
• Output Compare Channels: 18
• Input Capture Channels: 18
• Pwm Channels: 18
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

20.3
20.3.1
8210B–AVR–04/10
Input sources
Differential input
Figure 20-1. ADC overview
The input sources for the ADC are the analog voltage inputs that the ADC can measure and
convert. Four types of measurements can be selected:
The analog input pins are used for single ended and differential input, while the internal inputs
are directly available inside the device. Both PORTA and PORTB analog pins can then be used
as input for the ADC.
The MUX Control register select which input that is converted and the type of measurements in
one operation. The four types of measurements and their corresponding MUX selections are
shown in
The ADC itself is always differential, also for single ended inputs where the negative input for the
ADC will be connected to an fixed internal value.
When differential input is selected all analog input pins can be selected as positive input, and
analog input pins 0 to 3 can be selected as negative input. The ADC must be set in signed mode
when differential input is used.
• Differential input
• Differential input with gain
• Single ended input
• Internal input
Figure 20-2 on page 226
1-64 X
M U X selection
to
Figure 20-6 on page
Reference selection
C onfiguration
triggers
AD C
Event
228.
R esult R egister
XMEGA D
225