SAM7S16 Atmel Corporation, SAM7S16 Datasheet - Page 141

• Manufacturer Part Number: SAM7S16
• Manufacturer: Atmel Corporation

Specifications of SAM7S16

• Flash (kbytes): 16 Kbytes
• Pin Count: 48
• Max. Operating Frequency: 55 MHz
• Cpu: ARM7TDMI
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 21
• Ext Interrupts: 21
• Usb Speed: No
• Usb Interface: No
• Spi: 1
• Twi (i2c): 1
• Uart: 2
• Ssc: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 8
• Adc Resolution (bits): 10
• Adc Speed (ksps): 384
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 4
• Self Program Memory: NO
• Dram Memory: No
• Nand Interface: No
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 3.0 to 3.6
• Fpu: No
• Mpu / Mmu: no / no
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

20.3.4.6
20.3.4.7
6175L–ATARM–28-Jul-11
Flash Security Bit Command
SAM7S512 Select EFC Command
GP NVM bits can be read using Get GPNVM Bit command (GGPB). When a bit set in the Bit
Mask is returned, then the corresponding GPNVM bit is set.
Table 20-28. Get General-purpose NVM Bit Command
Security bits can be set using Set Security Bit command (SSE). Once the security bit is active,
the Fast Flash programming is disabled. No other command can be run. Only an event on the
Erase pin can erase the security bit once the contents of the Flash have been erased.
The SAM7S512 security bit is controlled by the EFC0. To use the Set Security Bit command,
the EFC0 must be selected using the Select EFC command.
Table 20-29. Set Security Bit Command
Once the security bit is set, it is not possible to access FFPI. The only way to erase the security
bit is to erase the Flash.
In order to erase the Flash, the user must perform the following:
Then it is possible to return to FFPI mode and check that Flash is erased.
The commands WPx, EA, xLB, xFB are executed using the current EFC controller. The default
EFC controller is EFC0. The Select EFC command (SEFC) allows selection of the current EFC
controller.
Table 20-30. Select EFC Command
Read/Write
Write
Read
Read/Write
Write
Step
1
2
• Power-off the chip
• Power-on the chip with TST = 0
• Assert Erase during a period of more than 220 ms
• Power-off the chip
Handshake Sequence
Write handshaking
Write handshaking
DR Data
GGPB
Bit Mask
DR Data
SSE
MODE[3:0]
CMDE
DATA
DATA[15:0]
SEFC
0 = Select EFC0
1 = Select EFC1
SAM7S Series
141