LPC2925 NXP Semiconductors, LPC2925 Datasheet - Page 34

• Manufacturer Part Number: LPC2925
• Description: (LPC2921 - LPC2925) ARM9 microcontroller
• Manufacturer: NXP Semiconductors

NXP Semiconductors
LPC2921_2923_2925_0
Preliminary data sheet
www.DataSheet4U.com
6.14.2 Pin description
6.14.3 Clock description
6.14.4 Analog-to-digital converter
The pins of the LPC2921/2923/2925 MSCSS associated with the two ADC modules are
described in
Section
Section
Section
Remark: The IDX0 function for the QEI, the external start function for ADC1, and the
TRAP0/1 functions for the PWM0/1 are not pinned out on the LPC2921/2923/2925.
The MSCSS is clocked from a number of different sources:
Each ADC has two clock areas; a APB part clocked by CLK_MSCSS_ADCx_APB (x = 1
or 2) and a control part for the analog section clocked by CLK_ADCx = 1 or 2), see
Section
All clocks are derived from the BASE_MSCSS_CLK, except for CLK_SYS_MSCSS_A
which is derived form BASE_SYS_CLK, and the CLK_ADCx clocks which are derived
from BASE_CLK_ADC. If specific PWM or ADC modules are not used their corresponding
clocks can be switched off.
The MSCSS in the LPC2921/2923/2925 includes two 10-bit successive-approximation
analog-to-digital converters.
The key features of the ADC interface module are:
•
•
•
•
•
•
•
•
•
•
•
•
•
CLK_SYS_MSCSS_A clocks the AHB side of the AHB-to-APB bus bridge
CLK_MSCSS_APB clocks the subsystem APB bus
CLK_MSCSS_MTMR0/1 clocks the timers
CLK_MSCSS_PWM0..3 clocks the PWMs.
ADC1 and ADC2: Eight analog inputs; time-multiplexed; measurement range up to
3.3 V.
External reference-level inputs.
400 ksamples per second at 10-bit resolution up to 1500 ksamples per second at 2-bit
resolution.
Programmable resolution from 2-bit to 10-bit.
Single analog-to-digital conversion scan mode and continuous analog-to-digital
conversion scan mode.
Optional conversion on transition on external start input, timer capture/match signal,
PWM_sync or ‘previous’ ADC.
Converted digital values are stored in a register for each channel.
Optional compare condition to generate a ‘less than’ or an ‘equal to or greater than’
compare-value indication for each channel.
Power-down mode.
6.14.5.4, pins directly connected to the MSCSS timer 1 module are described in
6.14.6.1, and pins connected to the quadrature encoder interface are described in
6.14.7.1.
6.7.2.
Section
Rev. 00.01 — 24 October 2008
6.14.4.2. Pins connected to the four PWM modules are described in
ARM9 microcontroller with CAN and LIN
LPC2921/2923/2925
© NXP B.V. 2008. All rights reserved.
34 of 81