ISP1362EE/01 PHILIPS [NXP Semiconductors], ISP1362EE/01 Datasheet - Page 2

• Manufacturer Part Number: ISP1362EE/01
• Description: Single-chip Universal Serial Bus On-The-Go controller
• Manufacturer: PHILIPS [NXP Semiconductors]

Philips Semiconductors
9397 750 12337
Product data
USB device:
Supports two USB ports: port 1 and port 2
Supports software-controlled connection to the USB bus (SoftConnect™)
Supports good USB connection indicator that blinks with traffic (GoodLink™)
Complies with USB power management requirements
Supports internal power-on and low-voltage reset circuit, with possibility of a
software reset
Supports operation over the extended USB voltage range (4.0 V to 5.5 V) with
5 V tolerant I/O pads
High-speed parallel interface to most CPUs available in the market, such as
Hitachi SH-3, Intel
Toshiba MIPS, ARM7/9, Motorola DragonBall™ and PowerPC™ Reduced
Instruction Set Computer (RISC):
Supports Programmed I/O (PIO) or Direct Memory Access (DMA)
Supports ‘suspend’ and remote wake-up
Uses 12 MHz crystal or direct clock source with on-chip Phase-Locked Loop
(PLL) for low Electro-Magnetic Interference (EMI)
Operates at +3.3 V power supply
Operating temperature range from 40 C to 85 C
Available in 64-pin LQFP and TFBGA packages.
USB host:
Supports integrated physical 4096 bytes of multiconfiguration memory
Supports all four types of USB transfers: control, bulk, interrupt and
isochronous
Supports multiframe buffering for isochronous transfer
Supports automatic interrupt polling rate mechanism
Supports paired buffering for bulk transfer
Directly addressable memory architecture; memory can be updated on-the-fly
Supports high performance USB interface device with integrated Serial
Interface Engine (SIE), buffer memory and transceiver
Supports fully autonomous and multiconfiguration DMA operation
Supports up to 14 programmable USB endpoints with 2 fixed control IN/OUT
endpoints
Supports integrated physical 2462 bytes of multiconfiguration memory
Supports endpoints with double buffering to increase throughput and ease
real-time data transfer
Supports controllable LazyClock (110 kHz
Port 1 can be configured to function as a downstream port, an upstream port
or an OTG port
Port 2 can be used only as a downstream port
16-bit data bus
10 Mbyte/s data transfer rate between the microprocessor and ISP1362
Rev. 03 — 06 January 2004
®
StrongARM
®
, Philips XA, Fujitsu SPARClite
Single-chip USB OTG controller
50 %) output during ‘suspend’
© Koninklijke Philips Electronics N.V. 2004. All rights reserved.
®
ISP1362
, NEC and
2 of 150