SC18IS602BIPW,112 NXP Semiconductors, SC18IS602BIPW,112 Datasheet - Page 15

• Manufacturer Part Number: SC18IS602BIPW,112
• Description: IC BRIDGE SPI/I2C 16-TSSOP
• Manufacturer: NXP Semiconductors

Specifications of SC18IS602BIPW,112

• Controller Type: I²C Bus Controller
• Interface: I²C
• Voltage - Supply: 2.4 V ~ 3.6 V
• Current - Supply: 11mA
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 16-TSSOP
• Operating Temperature Classification: Military
• Operating Temperature (max): 125C
• Package Type: TSSOP
• Rad Hardened: No
• Maximum Operating Frequency: 4.5 MHz
• Maximum Operating Temperature: + 125 C
• Minimum Operating Temperature: - 55 C
• Mounting Style: SMD/SMT
• Supply Voltage (max): 3.6 V
• Supply Voltage (min): 2.4 V
• For Use With: 568-4705 - DEMO BOARD I2C TO SPI SC18IS602
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 568-4785-5; 935286182112; SC18IS602BIPW; SC18IS602BIPW,112; SC18IS602BIPW

NXP Semiconductors
9. Limiting values
Table 11.
In accordance with the Absolute Maximum Rating System (IEC 60134).
[1]
[2]
[3]
SC18IS602_602B_603_4
Product data sheet
Symbol
T
T
V
I
I
I
P
OH(I/O)
OL(I/O)
I/O(tot)(max)
amb(bias)
stg
n
tot
/pack
This product includes circuitry specifically designed for the protection of its internal devices from the damaging effects of excessive
static charge. Nonetheless, it is suggested that conventional precautions be taken to avoid applying greater than the rated maximum.
Parameters are valid over the operating temperature range unless otherwise specified. All voltages are with respect to V
otherwise noted.
Based on package heat transfer, not device power consumption.
Limiting values
Parameter
bias ambient temperature
storage temperature
voltage on any other pin
HIGH-level output current per input/output pin
LOW-level output current per input/output pin
maximum total I/O current
total power dissipation per package
You can see that on the I
SPI bus. The first byte is the SC18IS60x address, followed by three dummy data
bytes. These dummy data bytes correspond to the three bytes sent to the EEPROM
before it actually places data on the bus (command 03h, subaddress 0030h).
Rev. 04 — 11 March 2008
2
C-bus the first four bytes do not contain the data from the
Conditions
operating
referenced to V
[1][2]
SC18IS602/602B/603
SS
[3]
Min
-
-
-
-
55
65
0.5
I
2
C-bus to SPI bridge
Max
+125
+150
+5.5
8
20
120
1.5
© NXP B.V. 2008. All rights reserved.
SS
unless
Unit
V
mA
mA
mA
W
C
C
15 of 25