peb20560 Infineon Technologies Corporation, peb20560 Datasheet - Page 321

• Manufacturer Part Number: peb20560
• Description: Dsp Oriented Pbx Controller Doc
• Manufacturer: Infineon Technologies Corporation

Semiconductor Group
5.1.1.6.11 Status Register (STAR)
Access: read
Reset value: 48
XDOV
XFW
Note: XFW is only valid when CEC = 0.
AREP/
XREP
RFR
RLI
Note: Significant in point-to-point configurations!
CEC
XAC
AFI
bit 7
XDOV
In this case the receive byte count (RBCH, RBCL) is greater than the
programmed receive length.
Transmit Data Overflow.
A ‘1’ indicates, that more than 32 bytes have been written into the XFIFO.
XFIFO Write enable.
A ‘1’ indicates, that data can be written into the XFIFO.
Auto Repeat/Transmission Repeat.
Read back value of the corresponding command bit CMDR:AREP/XREP.
RFIFO Read enable.
A ‘1’ indicates, that valid data is in the RFIFO and read access is enabled.
RFR is set with the RME- or RPF-interrupt and reset when executing the
RMC-command.
Receiver Line Inactive.
Neither flags as inter frame time fill nor frames are received via the receive
line.
Command Execution.
When ‘0’ no command is currently executed, the CMDR-register can be
written to.
When ‘1’ a command (written previously to CMDR) is currently executed, no
further command must temporarily be written to the CMDR-register.
Transmitter Active.
A ‘1’ indicates, that the transmitter is currently active.
In bus mode the transmitter is considered active also when it waits for bus
access.
Additional Frame Indication.
A ‘1’ indicates, that one or more completely received frames or the last part
of a frame are in the CPU inaccessible part of the RFIFO.
XFW
H
AREP/
XREP
RFR
5-78
RLI
CEC
Description of Registers
XAC
PEB 20560
bit 0
2003-08
AFI