S9S12G64F0MLF Freescale Semiconductor, S9S12G64F0MLF Datasheet - Page 1182

• Manufacturer Part Number: S9S12G64F0MLF
• Description: 16-bit Microcontrollers - MCU S12 Core,64kFlash,Au
• Manufacturer: Freescale Semiconductor

Specifications of S9S12G64F0MLF

• Rohs: yes
• Core: S12
• Processor Series: MC9S12G
• Data Bus Width: 16 bit
• Maximum Clock Frequency: 25 MHz
• Program Memory Size: 64 KB
• Data Ram Size: 2 KB
• On-chip Adc: Yes
• Operating Supply Voltage: 3.13 V to 5.5 V
• Operating Temperature Range: - 40 C to + 125 C
• Package / Case: LQFP-48
• Mounting Style: SMD/SMT

240 KByte Flash Module (S12FTMRG240K2V1)
31.4.6.15 Program EEPROM Command
The Program EEPROM operation programs one to four previously erased words in the EEPROM block.
The Program EEPROM operation will confirm that the targeted location(s) were successfully programmed
upon completion.
Upon clearing CCIF to launch the Program EEPROM command, the user-supplied words will be
transferred to the Memory Controller and be programmed if the area is unprotected. The CCOBIX index
value at Program EEPROM command launch determines how many words will be programmed in the
EEPROM block. The CCIF flag is set when the operation has completed.
31.4.6.16 Erase EEPROM Sector Command
The Erase EEPROM Sector operation will erase all addresses in a sector of the EEPROM block.
1184
Register
FSTAT
A Flash word must be in the erased state before being programmed.
Cumulative programming of bits within a Flash word is not allowed.
Table 31-62. Program EEPROM Command FCCOB Requirements
CCOBIX[2:0]
MGSTAT1
MGSTAT0
ACCERR
Error Bit
FPVIOL
Table 31-63. Program EEPROM Command Error Handling
000
001
010
011
100
101
MC9S12G Family Reference Manual,
Set if CCOBIX[2:0] < 010 at command launch
Set if CCOBIX[2:0] > 101 at command launch
Set if command not available in current mode (see
Set if an invalid global address [17:0] is supplied
Set if a misaligned word address is supplied (global address [0] != 0)
Set if the requested group of words breaches the end of the EEPROM block
Set if the selected area of the EEPROM memory is protected
Set if any errors have been encountered during the verify operation
Set if any non-correctable errors have been encountered during the verify
operation
Global address [15:0] of word to be programmed
0x11
Word 1 program value, if desired
Word 2 program value, if desired
Word 3 program value, if desired
CAUTION
Word 0 program value
FCCOB Parameters
Error Condition
identify the EEPROM block
Global address [17:16] to
Rev.1.23
Table
31-27)
Freescale Semiconductor