EP2AGX95EF29C4N Altera, EP2AGX95EF29C4N Datasheet - Page 578

• Manufacturer Part Number: EP2AGX95EF29C4N
• Description: IC ARRIA II GX FPGA 95K 780FBGA
• Manufacturer: Altera
• Series: Arria II GXr

Specifications of EP2AGX95EF29C4N

• Number Of Logic Elements/cells: 89178
• Number Of Labs/clbs: 3747
• Total Ram Bits: 6679
• Number Of I /o: 372
• Voltage - Supply: 0.87 V ~ 0.93 V
• Mounting Type: Surface Mount
• Operating Temperature: 0°C ~ 85°C
• Package / Case: 780-FBGA
• Family Name: Arria® II GX
• Number Of Logic Blocks/elements: 93674
• # I/os (max): 372
• Frequency (max): 500MHz
• Operating Supply Voltage (typ): 900mV
• Logic Cells: 93674
• Ram Bits: 7025459.2
• Operating Supply Voltage (min): 0.87V
• Operating Supply Voltage (max): 0.93V
• Operating Temp Range: 0C to 85C
• Operating Temperature Classification: Commercial
• Mounting: Surface Mount
• Pin Count: 780
• Package Type: FC-FBGA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Number Of Gates: -
• Lead Free Status / Rohs Status: Compliant

4–4
Transceiver Reset Sequences
Arria II Device Handbook Volume 2: Transceivers
f
1
The dynamic reconfiguration controller is always enabled when a receiver exists in a
transceiver-based design even if the channel will not be reconfigured. The dynamic
reconfiguration controller is used for receiver offset cancellation. Because of this, the
busy signal from the dynamic reconfiguration controller must always be monitored
when instantiating a receiver.
For more information about reset and offset cancellation, refer to the reset waveforms
and the “Offset Cancellation” section of
in Arria II Devices.
You can configure transceiver channels in Arria II GX and GZ devices in various
configurations. In all functional modes except XAUI functional mode, transceiver
channels can be either bonded or non-bonded. In XAUI functional mode, transceiver
channels must be bonded. In PCI Express
channels can be either bonded or non-bonded and need to follow a specific reset
sequence.
The two categories of reset sequences for the Arria II device family described in this
chapter are:
■
■
“All Supported Functional Modes Except PCIe Functional Mode” on page 4–6
describes the reset sequences in bonded and non-bonded configurations.
“PCIe Functional Mode” on page 4–15
initialization/compliance phase and normal operation phase in PCIe functional
modes.
AN 558: Implementing Dynamic Reconfiguration
Chapter 4: Reset Control and Power Down in Arria II Devices
®
describes the reset sequence for the
(PIPE) (PCIe) functional mode, transceiver
December 2010 Altera Corporation
Transceiver Reset Sequences