TMPM370FYDFG Toshiba, TMPM370FYDFG Datasheet - Page 276

• Manufacturer Part Number: TMPM370FYDFG
• Description: Microcontrollers (MCU) MCU w/ ARM Cortex-M3 256K FLASH, 10K RAM
• Manufacturer: Toshiba

Specifications of TMPM370FYDFG

• Processor Series: TX03
• Core: ARM Cortex M3
• 3rd Party Development Tools: MDK-ARM, RL-ARM, ULINK2
• Product Summaries: Summary
• Lead Free: Yes
• Rohs Compatible Product(s): Available
• Rom (kbytes): 256K
• Rom Type: Flash
• Ram (kbytes): 10K
• Number Of Pins: 100
• Package: QFP(14x20)
• Vcc: 5V
• Cpu Mhz: 80
• Ssp (ch) Spi: -
• I2c/sio (ch): -
• Uart/sio (ch): 4
• Usb: -
• Can: -
• Ethernet: -
• External Bus Interface: N
• Cs/wait Controller (ch): -
• Dma Controller: -
• 10-bit Da Converter: -
• 10-bit Ad Converter: -
• 12-bit Ad Converter: 27
• 16-bit Timer / Counter: 8
• Motor / Igbt Control: Vector Engine
• Real Time Clock: -
• Watchdog Timer: Y
• Osc Freq Detect: Y
• Clock Gear: Y
• Low-power Hold Function: -
• Remote Control Interface: -
• Hardware Cec Controller: -
• Comparators: 4
• Low-voltage Detector: Y
• Etm Hardware Trace: 2-bit
• Lead Free Status / Rohs Status: Details

executed individually or specified as a startup task, use the task number shown in this table.
executed (VETASKAPP register) and repeat count (VEREPTIME register).
Vector Engine executes an output schedule first, enters a standby state, and then starts executing an input
schedule by a start trigger.
Enable the Vector Engine with the VEEN register. Specify a schedule (VEACTSCH register), task to be
A schedule of the Vector Engine is comprised of an output schedule and an input schedule. Typically, the
An output schedule is started:
i) By the VECPURUNTRG command. In this case, the task specified in the VETASKAPP register is
ii) On a repeat start (when VEREPTIME ≥ 2) after the corresponding input schedule is completed.
Table 15-7 gives a summary of tasks executed in output and input schedules. When each task is to be
An input schedule is started:
i) By a start trigger (selected in the VETRGMODE register) after the corresponding output schedule is
ii) By the VECPURUNTRG command. In this case, the task specified in the VETASKAPP register is
15.5.2 Summary of Tasks
15.5.1.2
executed.
completed.
executed.
schedule
schedule
Output
Input
Start Control
Current control
SIN/COS computation
Output coordinate axis
conversion
Output phase conversion
Output control
Trigger generation
Input processing
Input phase conversion
Input coordinate axis
conversion
Task
Table 15-7 List of Tasks
TMPM370 15-35
Controls dq currents.
Performs sine/cosine computation and
phase interpolation.
Converts dq coordinates to αβ coordinates.
Converts 2-phase to 3-phase.
Converts data to PMD setting format.
Switches PWM shift.
Generates synchronization trigger timing.
Captures AD conversion results and
converts them into fixed-point format
Converts 2-phase to 3-phase.
Converts αβ coordinates to dq coordinates.
Description
Task Number
5
6
7
8
0
1
2
3
4
Vector Engine (VE)
TMPM370