TMPM370FYDFG Toshiba, TMPM370FYDFG Datasheet - Page 317

• Manufacturer Part Number: TMPM370FYDFG
• Description: Microcontrollers (MCU) MCU w/ ARM Cortex-M3 256K FLASH, 10K RAM
• Manufacturer: Toshiba

Specifications of TMPM370FYDFG

• Processor Series: TX03
• Core: ARM Cortex M3
• 3rd Party Development Tools: MDK-ARM, RL-ARM, ULINK2
• Product Summaries: Summary
• Lead Free: Yes
• Rohs Compatible Product(s): Available
• Rom (kbytes): 256K
• Rom Type: Flash
• Ram (kbytes): 10K
• Number Of Pins: 100
• Package: QFP(14x20)
• Vcc: 5V
• Cpu Mhz: 80
• Ssp (ch) Spi: -
• I2c/sio (ch): -
• Uart/sio (ch): 4
• Usb: -
• Can: -
• Ethernet: -
• External Bus Interface: N
• Cs/wait Controller (ch): -
• Dma Controller: -
• 10-bit Da Converter: -
• 10-bit Ad Converter: -
• 12-bit Ad Converter: 27
• 16-bit Timer / Counter: 8
• Motor / Igbt Control: Vector Engine
• Real Time Clock: -
• Watchdog Timer: Y
• Osc Freq Detect: Y
• Clock Gear: Y
• Low-power Hold Function: -
• Remote Control Interface: -
• Hardware Cec Controller: -
• Comparators: 4
• Low-voltage Detector: Y
• Etm Hardware Trace: 2-bit
• Lead Free Status / Rohs Status: Details

17. 12-Bit Analog-to-Digital Converters
motor 0. Three of six inputs are connected with operational amp/ comparator outputs. Thus twelve
inputs can use for external input.
motor 0. And two inputs are able to use for shut resistor currents of motor 1. four of eight inputs are
connected with operational amp/ comparator outputs. Thus thirteen inputs can use for external input.
AINA11/AINB2, AINB3 to AINB12) can also be used as input/output ports.
The TMPM370 FY contains two 12-bit successive-approximation analog-to-digital converters (ADCs).
The ADC unit A (ADC A) has 15 analog inputs. Six inputs are able to use for shunt resistor currents of
The ADC unit B (ADC B) has 17 analog inputs. Six inputs are able to use for shunt resistor currents of
Twenty two external analog input pins (AINA0 to AINA8, AINA9/AINB0, AINA10/AINB1,
Functions and features
(2) It can select analog input, in the Software Trigger Program and the Constant Trigger Program.
(3) The ADCs has twelve register for AD conversion result.
(4) The ADCs generate interrupt signal at the end of the program which was started by PMD trigger
(5) The ADCs generate interrupt signal at the end of the program which are the Software Trigger
(6) The ADCs have the AD conversion monitoring function. When this function is enabled, an interrupt
(1) It can select analog input and start AD conversion when receiving trigger signal from PMD or
TMRB(interrupt).
and TMRB trigger.
Program and the Constant Trigger Program.
is generated when a conversion result matches the specified comparison value.
TMPM370 17-1
Analog/ Digital Converter
TMPM370