TMPM330FWFG Toshiba, TMPM330FWFG Datasheet - Page 396

• Manufacturer Part Number: TMPM330FWFG
• Description: Microcontrollers (MCU) MCU w/ ARM Cortex-M3 128K FLASH, 8K SRAM
• Manufacturer: Toshiba

Specifications of TMPM330FWFG

• Processor Series: TX03
• Core: ARM Cortex M3
• 3rd Party Development Tools: MDK-ARM, RL-ARM, ULINK2
• Product Summaries: Summary
• Lead Free: Yes
• Rohs Compatible Product(s): Available
• Rom (kbytes): 128K
• Rom Type: Flash
• Ram (kbytes): 8K
• Number Of Pins: 100
• Package: LQFP(14×14)
• Vcc: 3V
• Cpu Mhz: 40
• Ssp (ch) Spi: -
• I2c/sio (ch): 3
• Uart/sio (ch): 3
• Usb: -
• Can: -
• Ethernet: -
• External Bus Interface: -
• Cs/wait Controller (ch): -
• Dma Controller: -
• 10-bit Da Converter: -
• 10-bit Ad Converter: 12
• 12-bit Ad Converter: -
• 16-bit Timer / Counter: 10
• Motor / Igbt Control: -
• Real Time Clock: 1
• Watchdog Timer: Y
• Osc Freq Detect: -
• Clock Gear: Y
• Low-power Hold Function: -
• Remote Control Interface: Y
• Hardware Cec Controller: Y
• Comparators: -
• Low-voltage Detector: -
• Etm Hardware Trace: 4-bit
• Lead Free Status / Rohs Status: Details

18 Flash Memory Operation
User Boot Mode
Determine the conditions (e.g., pin states) required for the flash memory to enter User Boot mode and
the I/O bus to be used to transfer new program code. Create hardware and software accordingly. Before
installing the TMPM330 on a printed circuit board, write the following program routines into an arbitrary
flash block using programming equipment.
After
User Boot mode. If mode switching conditions are met, the flash memory enters User Boot mode. (All
interrupts including NMI must be disabled while in User Boot mode.)
(Step-1)
(Step-2)
(1-A)
(a) Mode judgment routine: Code to determine whether or not to switch to User Boot mode
(b) Programming routine: Code to download new program code from a host controller and
(c) Copy routine: Code to copy the data described in (b) from the TMPM330 flash memory to either
RESET
re-program the flash memory
the TMPM330 on-chip RAM or external memory device.
Method 1: Storing a Programming Routine in the Flash Memory
is released, the reset procedure determines whether to put the TMPM330 flash memory in
Old Application Program
(a)
(b) Programming routine
(c) Copy routine
(a) Mode Judgment Routine
(b) Programming Routine
(c) Copy routine
Old Application Program
(TMPM330)
Flash memory
Flash memory
[Reset Procedure]
Mode Judgment Routine
(TMPM330)
[Reset Procedure]
Code
Code
Under development
Page384
(I/O)
(I/O)
(Host)
RAM
(Host)
RAM
New Application
New Application
Program Code
Program Code
Conditions for
entering User Boot
mode (defined by
the user)
0 → 1 RESET
TMPM330