PIC12C672-10/SM Microchip Technology, PIC12C672-10/SM Datasheet - Page 98

• Manufacturer Part Number: PIC12C672-10/SM
• Description: IC MCU OTP 2KX14 A/D 8-SOIJ
• Manufacturer: Microchip Technology
• Series: PIC® 12Cr

Specifications of PIC12C672-10/SM

• Core Processor: PIC
• Core Size: 8-Bit
• Speed: 10MHz
• Peripherals: POR, WDT
• Number Of I /o: 5
• Program Memory Size: 3.5KB (2K x 14)
• Program Memory Type: OTP
• Ram Size: 128 x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 5.5 V
• Data Converters: A/D 4x8b
• Oscillator Type: Internal
• Operating Temperature: 0°C ~ 70°C
• Package / Case: 8-SOIC (5.3mm Width), 8-SOP, 8-SOEIAJ
• For Use With: XLT08SO-1 - SOCKET TRANSITION 8SOIC 150/208AC164312 - MODULE SKT FOR PM3 16SOICISPICR1 - ADAPTER IN-CIRCUIT PROGRAMMING309-1048 - ADAPTER 8-SOIC TO 8-DIP309-1047 - ADAPTER 8-SOIC TO 8-DIPAC124001 - MODULE SKT PROMATEII 8DIP/SOIC
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Connectivity: -
• Other names: PIC12C672-10/SMR; PIC12C672-10/SMR

PICmicro MID-RANGE MCU FAMILY
6.2.1
6.2.2
6.2.3
DS31006A-page 6-4
Reset Vector
Interrupt Vector
Calibration Information
On any device, a reset forces the Program Counter (PC) to address 0h. We call this address the
“Reset Vector Address” since this is the address that program execution will branch to when a
device reset occurs.
Any reset will also clear the contents of the PCLATH register. This means that any branch at the
Reset Vector Address (0h) will jump to that location in PAGE0 of the program memory.
When an interrupt is acknowledged the PC is forced to address 0004h. We call this the “Interrupt
Vector Address”. When the PC is forced to the interrupt vector, the PCLATH register is not mod-
ified. Once in the service interrupt routine (ISR), this means that before any write to the PC, the
PCLATH register should be written with the value that will specify the desired location in program
memory. Before the PCLATH register is modified by the Interrupt Service Routine (ISR) the con-
tents of the PCLATH may need to be saved, so it can be restored before returning from the ISR.
Some devices have calibration information stored in their program memory. This information is
programmed by Microchip when the device is under final test. The use of these values allows the
application to achieve better results. The calibration information is typically at the end of program
memory, and is implemented as a RETLW instruction with the literal value being the specified cal-
ibration information.
Note:
For windowed devices, write down all calibration values BEFORE erasing. This
allows the device’s calibration values to be restored when the device is re-pro-
grammed. When possible writing the values on the package is recommended.
1997 Microchip Technology Inc.