w83l517g Winbond Electronics Corp America, w83l517g Datasheet - Page 112

• Manufacturer Part Number: w83l517g
• Description: Winbond Lpc I/o For Notebook W83l517d/ W83l517d-f
• Manufacturer: Winbond Electronics Corp America

CR23 (Default 0x00)
CR24 (Default ss00,00ssb)
Bit 0: PNPCSV
Bit 7 : Keyboard address decoder control
Bit 6: CLKSEL(Enable 48Mhz)
Bit[5:4]: ROM size select
Bit3:MEMW# Select (PIN97)
Bit2: Reserved.
Bit1 : Enable Flash ROM Interface
Bit 0: IPD (Immediate Power Down). When set to 1, it will put the whole chip into power down
Bit 7 ~ 1: Reserved.
= 0 The clock input on Pin 1 should be 24 MHz.
= 1 The clock input on Pin 1 should be 48 MHz.
The corresponding power-on setting pin is PEN48 (pin 61).
= 00 1Mb
= 0 MEMW# of flash interface is Disabled.
= 1 MEMW# of flash interface is Enabled.
This bit is read only, and set/reset by power-on setting pin. The corresponding power-on
setting pin is PENROM#(pin 69)
= 0 Flash ROM Interface is enabled after hardware reset
= 1 Flash ROM Interface is disabled after hardware reset
= 0 Enable keyboard address (interface: KBCS# and MCCS#) decoder and IRQ1 , IRQ12
= 1 Disable keyboard interface.
01 2Mb
10 4Mb
11 Reserved
= 0 The Compatible PnP address select registers have default values.
= 1 The Compatible PnP address select registers have no default value.
mode immediately.
pass to SERIRQ.
The corresponding power-on setting pin is PENKBC# (pin 52)
The corresponding power-on setting pin is PNPCSV# (pin 43).
- 112 -
W83L517D/W83L517D-F