w83l517g Winbond Electronics Corp America, w83l517g Datasheet - Page 45

• Manufacturer Part Number: w83l517g
• Description: Winbond Lpc I/o For Notebook W83l517d/ W83l517d-f
• Manufacturer: Winbond Electronics Corp America

Bit 7-3: Reserved. These bits should be set to 0.
NOPREC (Bit 2):
This bit indicates no precompensation. It has no function and can be set by software.
DRATE1 DRATE0 (Bit 1, 0):
These two bits select the data rate of the FDC.
7. UART PORT
7.1
The UARTs are used to convert parallel data into serial format on the transmit side and convert serial
data to parallel format on the receiver side. The serial format, in order of transmission and reception,
is a start bit, followed by five to eight data bits, a parity bit (if programmed) and one, one and half (five-
bit format only) or two stop bits. The UARTs are capable of handling divisors of 1 to 65535 and
producing a 16x clock for driving the internal transmitter logic. Provisions are also included to use this
16x clock to drive the receiver logic. The UARTs also support the MIDI data rate. Furthermore, the
UARTs also include complete modem control capability and a processor interrupt system that may be
software trailed to the computing time required to handle the communication link. The UARTs have a
FIFO mode to reduce the number of interrupts presented to the CPU. In each UART, there are 16-
byte FIFOs for both receive and transmit mode.
7.2
7.2.1
The UART Control Register controls and defines the protocol for asynchronous data communications,
including data length, stop bit, parity, and baud rate selection.
Universal Asynchronous Receiver/Transmitter (UART A)
Register Address
UART Control Register (UCR) (Read/Write)
7
6
5
4
3
2
1
0
- 45 -
Data length select bit 0 (DLS0)
Data length select bit 1(DLS1)
Multiple stop bits enable (MSBE)
Parity bit enable (PBE)
Even parity enable (EPE)
Parity bit fixed enable (PBFE)
Set silence enable (SSE)
Baudrate divisor latch access bit (BDLAB)
W83L517D/W83L517D-F
Publication Release Date: May 23, 2005
Revision 1.0