D17760BP200ADV Renesas Electronics America, D17760BP200ADV Datasheet - Page 740

• Manufacturer Part Number: D17760BP200ADV
• Description: MPU 3V 8K,PB-FREE, 256-BGA
• Manufacturer: Renesas Electronics America
• Series: SuperH® SH7750r

Specifications of D17760BP200ADV

• Core Processor: SH-4
• Core Size: 32-Bit
• Speed: 200MHz
• Connectivity: Audio Codec, CAN, EBI/EMI, FIFO, I²C, MFI, MMC, SCI, Serial Sound, SIM, SPI, USB
• Peripherals: DMA, LCD, POR, WDT
• Number Of I /o: 69
• Program Memory Type: ROMless
• Ram Size: 48K x 8
• Voltage - Supply (vcc/vdd): 1.4 V ~ 1.6 V
• Data Converters: A/D 4x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 256-BGA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Program Memory Size: -

In T = 0 mode, if an error signal is received during transmission, the disputed data is automatically
repeated. This repetition generates no DMA transfer request, so it is possible to transmit the
number of bytes assigned to the DMAC.
For error handling with an interruput request to the CPU in transmission using the DMAC, set the
TIE bit to 0 to disable an SIMTXI request, and set the RIE bit to 1 to enable an SIMERI request.
Clear the ERS flag by sending an interrupt request to the CPU since it is not automatically cleared
once set when an error signal was received.
The receiver issues a receive data full DMA transfer request when the RDRF flag in SISSR is set
to 1. It is possible to start the DMAC to transfer data with a receive data full DMA transfer request
by setting this request as a DMAC startup factor in advance.
In T = 0 mode, if a parity error occurs during reception, a data repeat request is issued. Since the
RDRF flag is not set and a DMA transfer request is not issued, it is possible to receive the number
of bytes assigned to the DMAC.
For error handling with an interrupt to the CPU in reception using the DMAC, set the RIE and
EIO bits to 1 to disable an SIMRXI interrupt and to enable only an SIMERI request.
Clear the PER, ORER, and WAIT_ER flags by sending an interrupt request to the CPU since they
are not automatically cleared once set by a receive error.
For transmission/reception using the DMAC, the DMAC should be configured to be enabled
before configuring the smart card interface.
18.5
The following matters should be noted when using the smart card interface.
18.5.1
When the SISMPL register holds its initial value, the smart card interface operates at a serial clock
frequency (SIM_CLK) 372 times the transfer rate.
During reception, the smart card interface samples the falling edge of the start bit using the serial
SIM_CLK for internal synchronization. Received data is captured internally at the center of one
etu (at the rising edge of the 186th SIM_CLK pulse when one etu takes 372 SIM_CLK cycles).
This is shown in figure 18.7.
Rev. 2.00 Feb. 12, 2010 Page 656 of 1330
REJ09B0554-0200
Usage Notes
Receive data Timing