UPD78F0513AMC-GAA-AX Renesas Electronics America, UPD78F0513AMC-GAA-AX Datasheet - Page 473

• Manufacturer Part Number: UPD78F0513AMC-GAA-AX
• Description: MCU 8BIT 38PIN SSOP
• Manufacturer: Renesas Electronics America
• Series: 78K0/Kx2r

Specifications of UPD78F0513AMC-GAA-AX

• Core Processor: 78K/0
• Core Size: 8-Bit
• Speed: 20MHz
• Connectivity: 3-Wire SIO, I²C, LIN, UART/USART
• Peripherals: LVD, POR, PWM, WDT
• Number Of I /o: 31
• Program Memory Size: 32KB (32K x 8)
• Program Memory Type: FLASH
• Ram Size: 1K x 8
• Voltage - Supply (vcc/vdd): 1.8 V ~ 5.5 V
• Data Converters: A/D 6x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: *
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

78K0/Kx2
R01UH0008EJ0401 Rev.4.01
Jul 15, 2010
(b) Parity types and operation
The parity bit is used to detect a bit error in communication data. Usually, the same type of parity bit is used on
both the transmission and reception sides. With even parity and odd parity, a 1-bit (odd number) error can be
detected. With zero parity and no parity, an error cannot be detected.
Caution Fix the PS61 and PS60 bits to 0 when the device is used in LIN communication operation.
(i)
(ii) Odd parity
(iii) 0 parity
(iv) No parity
Even parity
• Transmission
• Reception
• Transmission
• Reception
The parity bit is cleared to 0 when data is transmitted, regardless of the transmit data.
The parity bit is not detected when the data is received. Therefore, a parity error does not occur regardless
of whether the parity bit is “0” or “1”.
No parity bit is appended to the transmit data.
Reception is performed assuming that there is no parity bit when data is received. Because there is no
parity bit, a parity error does not occur.
Transmit data, including the parity bit, is controlled so that the number of bits that are “1” is even.
The value of the parity bit is as follows.
If transmit data has an odd number of bits that are “1”: 1
If transmit data has an even number of bits that are “1”: 0
The number of bits that are “1” in the receive data, including the parity bit, is counted. If it is odd, a parity
error occurs.
Unlike even parity, transmit data, including the parity bit, is controlled so that the number of bits that are
“1” is odd.
If transmit data has an odd number of bits that are “1”: 0
If transmit data has an even number of bits that are “1”: 1
The number of bits that are “1” in the receive data, including the parity bit, is counted. If it is even, a parity
error occurs.
CHAPTER 15 SERIAL INTERFACE UART6
473