UPD78F0513AMC-GAA-AX Renesas Electronics America, UPD78F0513AMC-GAA-AX Datasheet - Page 734

• Manufacturer Part Number: UPD78F0513AMC-GAA-AX
• Description: MCU 8BIT 38PIN SSOP
• Manufacturer: Renesas Electronics America
• Series: 78K0/Kx2r

Specifications of UPD78F0513AMC-GAA-AX

• Core Processor: 78K/0
• Core Size: 8-Bit
• Speed: 20MHz
• Connectivity: 3-Wire SIO, I²C, LIN, UART/USART
• Peripherals: LVD, POR, PWM, WDT
• Number Of I /o: 31
• Program Memory Size: 32KB (32K x 8)
• Program Memory Type: FLASH
• Ram Size: 1K x 8
• Voltage - Supply (vcc/vdd): 1.8 V ~ 5.5 V
• Data Converters: A/D 6x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: *
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

78K0/Kx2
27.7.4 Communication commands
signals sent from the flash memory programmer to the 78K0/Kx2 microcontrollers are called commands, and the signals
sent from the 78K0/Kx2 microcontrollers to the dedicated flash memory programmer are called response.
commands are issued from the programmer and the 78K0/Kx2 microcontrollers perform processing corresponding to the
respective commands.
The response names sent from the 78K0/Kx2 microcontrollers are listed below.
R01UH0008EJ0401 Rev.4.01
Jul 15, 2010
The 78K0/Kx2 microcontrollers communicate with the dedicated flash memory programmer by using commands. The
The flash memory control commands of the 78K0/Kx2 microcontrollers are listed in the table below.
The 78K0/Kx2 microcontrollers return a response for the command issued by the dedicated flash memory programmer.
Verify
Erase
Blank check
Write
Getting information
Security
Others
Classification
ACK
NAK
Verify
Chip Erase
Block Erase
Block Blank Check
Programming
Status
Silicon Signature
Version Get
Checksum
Security Set
Reset
Oscillating Frequency Set
Command Name
memory programmer
Response Name
Dedicated flash
Table 27-8. Flash Memory Control Commands
Figure 27-12. Communication Commands
PASS
START
BUSY
PG-FP5
N G
POWER
Table 27-9. Response Names
Compares the contents of a specified area of the flash memory with
data transmitted from the programmer.
Erases the entire flash memory.
Erases a specified area in the flash memory.
Checks if a specified block in the flash memory has been correctly
erased.
Writes data to a specified area in the flash memory.
Gets the current operating status (status data).
Gets 78K0/Kx2 information (such as the part number and flash memory
configuration).
Gets the 78K0/Kx2 version and firmware version.
Gets the checksum data for a specified area.
Sets security information.
Used to detect synchronization status of communication.
Specifies an oscillation frequency.
Command
Response
Acknowledges command/data.
Acknowledges illegal command/data.
microcontrollers
Function
78K0/Kx2
Function
CHAPTER 27 FLASH MEMORY
All these
734