EPM2210GF256I5N Altera, EPM2210GF256I5N Datasheet - Page 47
![no-image](/images/manufacturer_photos/0/0/40/altera_sml.jpg)
EPM2210GF256I5N
Manufacturer Part Number
EPM2210GF256I5N
Description
MAX II
Manufacturer
Altera
Datasheet
1.EPM2210GM100I.pdf
(108 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Altera Corporation
March 2008
Bus Hold
Each MAX II device I/O pin provides an optional bus-hold feature. The
bus-hold circuitry can hold the signal on an I/O pin at its last-driven
state. Since the bus-hold feature holds the last-driven state of the pin until
the next input signal is present, an external pull-up or pull-down resistor
is not necessary to hold a signal level when the bus is tri-stated.
The bus-hold circuitry also pulls undriven pins away from the input
threshold voltage where noise can cause unintended high-frequency
switching. The designer can select this feature individually for each I/O
pin. The bus-hold output will drive no higher than V
overdriving signals. If the bus-hold feature is enabled, the device cannot
use the programmable pull-up option.
The bus-hold circuitry uses a resistor to pull the signal level to the last
driven state. The
Device Handbook gives the specific sustaining current for each V
voltage level driven through this resistor and overdrive current used to
identify the next-driven input level.
The bus-hold circuitry is only active after the device has fully initialized.
The bus-hold circuit captures the value on the pin present at the moment
user mode is entered.
Programmable Pull-Up Resistor
Each MAX II device I/O pin provides an optional programmable pull-up
resistor during user mode. If the designer enables this feature for an I/O
pin, the pull-up resistor holds the output to the V
pin’s bank.
1
Programmable Input Delay
The MAX II IOE includes a programmable input delay that is activated to
ensure zero hold times. A path where a pin directly drives a register, with
minimal routing between the two, may require the delay to ensure zero
hold time. However, a path where a pin drives a register through long
routing or through combinational logic may not require the delay to
achieve a zero hold time. The Quartus II software uses this delay to
ensure zero hold times when needed.
The programmable pull-up resistor feature should not be used
at the same time as the bus-hold feature on a given I/O pin.
DC and Switching Characteristics
MAX II Device Handbook, Volume 1
CCIO
chapter in the MAX II
CCIO
level of the output
MAX II Architecture
to prevent
CCIO
2–39