EPM2210GF256I5N Altera, EPM2210GF256I5N Datasheet - Page 81

• Manufacturer Part Number: EPM2210GF256I5N
• Description: MAX II
• Manufacturer: Altera

Altera Corporation
July 2008
This section describes and specifies the performance, internal, external,
and UFM timing specifications. All specifications are representative of
the worst-case supply voltage and junction temperature conditions.
Preliminary and Final Timing
Timing models can have either preliminary or final status. The
Quartus
compilation if the timing models are preliminary.
status of the MAX II device timing models.
Preliminary status means the timing model is subject to change. Initially,
timing numbers are created using simulation results, process data, and
other known parameters. These tests are used to make the preliminary
numbers as close to the actual timing parameters as possible.
Final timing numbers are based on actual device operation and testing.
These numbers reflect the actual performance of the device under the
worst-case voltage and junction temperature conditions.
Note to
(1)
EPM240
EPM240Z
EPM570
EPM570Z
EPM1270
EPM2210
Table 5–13. MAX II Device Timing Model Status
The MAX IIZ device timing models are only available in the Quartus II software
version 8.0 and later.
Table
®
Device
II software issues an informational message during the design
(1)
(1)
5–13:
Preliminary
v
v
—
—
—
—
MAX II Device Handbook, Volume 1
DC and Switching Characteristics
Table 5–13
Final
v
v
v
v
—
—
shows the
5–11