PIC10F322T-I/OT Microchip Technology, PIC10F322T-I/OT Datasheet - Page 42

• Manufacturer Part Number: PIC10F322T-I/OT
• Description: 896 B Flash, 64 B RAM, 4 I/O, 8bit ADC, PWM, CLC, DDS, CWG, TEMP Indicator, 2.3V
• Manufacturer: Microchip Technology

Specifications of PIC10F322T-I/OT

• Core: RISC
• Processor Series: PIC10F
• Data Bus Width: 8 bit
• Maximum Clock Frequency: 31 KHz
• Program Memory Size: 512 B
• Data Ram Size: 64 B
• Number Of Programmable I/os: 4
• Number Of Timers: 2
• Operating Temperature Range: - 40 C to + 85 C
• Package / Case: SOT-23-6
• Mounting Style: SMD/SMT
• Maximum Operating Temperature: + 85 C
• Program Memory Type: Flash
• Lead Free Status / Rohs Status: Details

PIC10(L)F320/322
6.1
Interrupts are disabled upon any device Reset. They
are enabled by setting the following bits:
• GIE bit of the INTCON register
• Interrupt Enable bit(s) for the specific interrupt
• PEIE bit of the INTCON register (if the Interrupt
The INTCON and PIR1 registers record individual inter-
rupts via interrupt flag bits. Interrupt flag bits will be set,
regardless of the status of the GIE, PEIE and individual
interrupt enable bits.
The following events happen when an interrupt event
occurs while the GIE bit is set:
• Current prefetched instruction is flushed
• GIE bit is cleared
• Current Program Counter (PC) is pushed onto the
• PC is loaded with the interrupt vector 0004h
The firmware within the Interrupt Service Routine (ISR)
should determine the source of the interrupt by polling
the interrupt flag bits. The interrupt flag bits must be
cleared before exiting the ISR to avoid repeated
interrupts. Because the GIE bit is cleared, any interrupt
that occurs while executing the ISR will be recorded
through its interrupt flag, but will not cause the
processor to redirect to the interrupt vector.
The RETFIE instruction exits the ISR by popping the
previous address from the stack, and setting the GIE
bit.
For additional information on a specific interrupt’s
operation, refer to its peripheral chapter.
DS41585A-page 42
events)
Enable bit of the interrupt event is contained in the
PIE1 register)
stack
Note 1: Individual interrupt flag bits are set,
2: All interrupts will be ignored while the GIE
Operation
regardless of the state of any other
enable bits.
bit is cleared. Any interrupt occurring
while the GIE bit is clear will be serviced
when the GIE bit is set again.
Preliminary
6.2
Interrupt latency is defined as the time from when the
interrupt event occurs to the time code execution at the
interrupt vector begins. The latency for synchronous
interrupts is 3 or 4 instruction cycles. For asynchronous
interrupts, the latency is 3 to 5 instruction cycles,
depending on when the interrupt occurs. See
and
details.
Section 6.3 “Interrupts During Sleep”
Interrupt Latency
 2011 Microchip Technology Inc.
Figure 6-2
for more