r4f2426 Renesas Electronics Corporation., r4f2426 Datasheet - Page 473

• Manufacturer Part Number: r4f2426
• Description: 16-bit Single-chip Microcomputer H8s Family / H8s/2400 Series
• Manufacturer: Renesas Electronics Corporation.

(3)
In external request mode, an EXDMA transfer cycle is started a minimum of three cycles after a
transfer request is accepted. The next transfer request is accepted after the end of a one-transfer-
unit EXDMA cycle. For external bus space CPU cycles, at least two bus cycles are generated
before the next EXDMA cycle.
If a transfer request is generated for another channel, an EXDMA cycle for the other channel is
generated before the next EXDMA cycle.
The EDREQ pin sensing timing is different for low level sensing and falling edge sensing. The
same applies to transfer request acceptance and transfer start timing.
Figures 8.35 to 8.38 show operation timing examples for various conditions.
φ pin
EDREQ
EDRAK
Bus cycle
ETEND
EDA bit
External Request/Cycle Steal Mode/Normal Transfer Mode
Figure 8.35 External Request/Cycle Steal Mode/Normal Transfer Mode
1
Bus release
(No Contention/Dual Address Mode/Low Level Sensing)
EXDMA
read
EXDMA
write
Bus release
3 cycles
Rev. 1.00 Sep. 19, 2008 Page 445 of 1270
Section 8 EXDMA Controller (EXDMAC)
EXDMA
Last transfer cycle
read
EXDMA
write
REJ09B0466-0100
0
Bus release