h8s-2646 Renesas Electronics Corporation., h8s-2646 Datasheet - Page 144

• Manufacturer Part Number: h8s-2646
• Description: Renesas 16-bit Single-chip Microcomputer H8s Family/h8s/2600 Series
• Manufacturer: Renesas Electronics Corporation.

Section 5 Interrupt Controller
5.4.3
Eight-level masking is implemented for IRQ interrupts and on-chip supporting module interrupts
by comparing the interrupt mask level set by bits I2 to I0 of EXR in the CPU with IPR.
Figure 5.6 shows a flowchart of the interrupt acceptance operation in this case.
[1] If an interrupt source occurs when the corresponding interrupt enable bit is set to 1, an
[2] When interrupt requests are sent to the interrupt controller, the interrupt with the highest
[3] Next, the priority of the selected interrupt request is compared with the interrupt mask level set
[4] When an interrupt request is accepted, interrupt exception handling starts after execution of the
[5] The PC, CCR, and EXR are saved to the stack area by interrupt exception handling. The PC
[6] The T bit in EXR is cleared to 0. The interrupt mask level is rewritten with the priority level of
[7] A vector address is generated for the accepted interrupt, and execution of the interrupt
Rev. 5.00 Sep 22, 2005 page 118 of 1136
REJ09B0257-0500
interrupt request is sent to the interrupt controller.
priority according to the interrupt priority levels set in IPR is selected, and lower-priority
interrupt requests are held pending. If a number of interrupt requests with the same priority are
generated at the same time, the interrupt request with the highest priority according to the
priority system shown in table 5.4 is selected.
in EXR. An interrupt request with a priority no higher than the mask level set at that time is
held pending, and only an interrupt request with a priority higher than the interrupt mask level
is accepted.
current instruction has been completed.
saved on the stack shows the address of the first instruction to be executed after returning from
the interrupt handling routine.
the accepted interrupt.
If the accepted interrupt is NMI, the interrupt mask level is set to H'7.
handling routine starts at the address indicated by the contents of that vector address.
Interrupt Control Mode 2