h8s-2646 Renesas Electronics Corporation., h8s-2646 Datasheet - Page 794

• Manufacturer Part Number: h8s-2646
• Description: Renesas 16-bit Single-chip Microcomputer H8s Family/h8s/2600 Series
• Manufacturer: Renesas Electronics Corporation.

Section 22 Power-Down Modes
22.13
1. When making a transition to subactive mode or watch mode, set the DTC to enter module stop
2. The on-chip peripheral modules (DTC and TPU) which halt operation in subactive mode
Rev. 5.00 Sep 22, 2005 page 768 of 1136
REJ09B0257-0500
mode (write 1 to the relevant bits in MSTPCR), and then read the relevant bits to confirm that
they are set to 1 before mode transition. Do not clear module stop mode (write 0 to the relevant
bits in MSTPCR) until a transition from subactive mode to high-speed mode or medium-speed
mode has been performed.
If a DTC activation source occurs in subactive mode, the DTC will be activated only after
module stop mode has been cleared and high-speed mode or medium-speed mode has been
entered.
cannot clear an interrupt in subactive mode. Therefore, if a transition is made to subactive
mode while an interrupt is requested, the CPU interrupt source cannot be cleared. Disable the
interrupts of each on-chip peripheral module before executing a SLEEP instruction to enter
subactive mode or watch mode.
Usage Notes