CY8C20X34 CYPRESS [Cypress Semiconductor], CY8C20X34 Datasheet - Page 162

• Manufacturer Part Number: CY8C20X34
• Description: Technical Reference Manual (TRM)
• Manufacturer: CYPRESS [Cypress Semiconductor]

PT_CFG
20.3.22 PT_CFG
This register is used to configure the programmable timer.
In the table above, note that reserved bits are grayed table cells and are not described in the bit description section below.
Reserved bits should always be written with a value of ‘0’. For additional information, refer to the
133
Bit
1
0
162
Individual Register Names and Addresses:
PT_CFG : 0,B0h
Access : POR
Bit Name
0,B0h
in the Programmable Timer chapter .
One Shot
START
Name
Programmable Timer Configuration Register
7
6
Description
0
1
0
1
Continuos count mode. Timer reloads the count value from the data registers upon each
terminal count, and continues counting.
One-shot mode. Timer goes through one complete count period and then stops. Upon com-
pletion, the START bit in this register is cleared.
Timer held in reset.
Timer counts down from a full count determined from its data registers (PT_DATA1,
PT_DATA0). When complete, it will either stop or reload and continue, based on the One
Shot bit in this register.
5
4
3
PSoC CY8C20x34 TRM, Version 1.0
2
Register Definitions on page
One Shot
RW : 0
1
0,B0h
START
RW : 0
0