HD6417618 RENESAS [Renesas Technology Corp], HD6417618 Datasheet - Page 519

• Manufacturer Part Number: HD6417618
• Description: 32-Bit RISC Microcomputer SuperHTM RISC engine Family / SH7618 Series
• Manufacturer: RENESAS [Renesas Technology Corp]

• When a break after execution is selected:
• When an address in a data access cycle is specified as a break condition:
• When an address and data in a data access cycle are specified as a break condition:
18.3.6
• Setting PCTE in BRCR to 1 enables PC traces. When branch (branch instruction, and
• The branch source address has different values due to the kind of branch.
• BRSR and BRDR have four pairs of queue structures. The top of queues is read first when the
The PC value saved is the address of the instruction to be executed following the instruction in
which the break condition matches. The fetched instruction is executed, and a break occurs
before the execution of the next instruction.
The PC value is the address of the instruction to be executed following the instruction that
matched the break condition. The instruction that matched the condition is executed and the
break occurs before the next instruction is executed.
The PC value is the start address of the instruction that follows the instruction already executed
when break processing started. When a data value is added to the break conditions, the break
will occur before the execution of an instruction that is within two instructions of the
instruction that matched the break condition. Therefore, where the break will occur cannot be
specified exactly.
interrupt) is generated, the branch source address and branch destination address are stored in
BRSR and BRDR, respectively.
 Branch instruction
 Interrupt and exception
address stored in the PC trace register is read. BRSR and BRDR share the read pointer. Read
BRSR and BRDR in order, the queue only shifts after BRDR is read. After switching the
PCTE bit (in BRCR) off and on, the values in the queues are invalid.
The branch instruction address.
The address of the instruction in which the interrupt or exception was accepted. This
address is equal to the return address saved onto the stack.
The start address of the interrupt or exception handling routine is stored in BRDR.
The TRAPA instruction belongs to interrupt and exception above.
PC Trace
Rev. 6.00 Jun. 12, 2007 Page 487 of 610
Section 18 User Break Controller (UBC)
REJ09B0131-0600