HD6417618 RENESAS [Renesas Technology Corp], HD6417618 Datasheet - Page 632

• Manufacturer Part Number: HD6417618
• Description: 32-Bit RISC Microcomputer SuperHTM RISC engine Family / SH7618 Series
• Manufacturer: RENESAS [Renesas Technology Corp]

Rev. 6.00 Jun. 12, 2007 Page 600 of 610
REJ09B0131-0600
Item
14.4.3 Synchronous Operation
Clock
Figure 14.13 Sample Flowchart
for Transmitting Serial Data
Figure 14.18 Sample Flowchart
for Transmitting/Receiving Serial
Data
19.6 Usage Notes
Page Revision (See Manual for Details)
376
378
382
470
Amended
When only receiving, the clock signal outputs while the
RE bit of SCSCR is 1 and the number of data in receive
FIFO is less than the receive FIFO data trigger number.
In this case, 8 × (16 + 1) = 136 pulses of synchronous
clock are output. To perform reception of n characters
of data, select an external clock as the clock source. If
an internal clock should be used, set RE = 1 and TE =
1 and receive n characters of data simultaneously with
the transmission of n characters of dummy data.
Amended
Amended
Added
2. Since the HIFMD pin is not initially set to function as
3. When using a multiplexed pin with a function not
a general port pin, it must be pulled up or down
externally to fix its state.
selected with its initial value (for example, using the
PB12/CS3 pin, the initial function of which is PB12,
as the CS3 pin), the pin must be pulled up or down
externally at least after a reset until its pin function is
selected by software to fix its state.
:
Write transmit data to SCFTDR
Read TDFE and TEND flags
in SCFSR while they are 1, then
clear them to 0
Read TDFE flag in SCFSR
No
Start of transmission
Start of transmission and reception
Write transmit data to SCFTDR
Read TDFE and TEND flags
in SCFSR while they are 1, then
clear them to 0
Read TDFE flag in SCFSR
TDFE = 1?
Yes
Initialization
TDFE = 1?
Yes
No
[1]
[1]
[1] SCIF status check and transmit data
[2] Serial transmission continuation
write:
TDFE flag is set to 1, then write
transmit data to SCFTDR. Read the
TDFE and TEND flags while they are
1, then clear them to 0.
procedeure:
1 from the TDFE flag to confirm that
writing is possible, them write data to
Read SCFSR and check that the
To continue serial transmission, read
[1] SCIF status check and transmit data
[2] Receive error handling:
[3] SCIF status check and receive data
write:
TDFE flag is set to 1, then write
transmit data to SCFTDR. Read the
TDFE and TEND flags while they are
1, then clear them to 0. The transition
of the TDFE flag from 0 to 1 can also
be identified by a TXI interrupt.
identify any error, perform the
appropriate error handling, then clear
the ORER flag to 0. Reception cannot
be resumed while the ORER flag is
set to 1.
read:
Read SCFSR and check that the
Read the ORER flag in SCLSR to