MT46H64M16LFBF-6 IT:B Micron Technology Inc, MT46H64M16LFBF-6 IT:B Datasheet - Page 46

• Manufacturer Part Number: MT46H64M16LFBF-6 IT:B
• Description: 64MX16 MOBILE DDR SDRAM PLASTIC IND TEMP GREEN VFBGA 1.8V
• Manufacturer: Micron Technology Inc

Specifications of MT46H64M16LFBF-6 IT:B

• Lead Free Status / RoHS Status: Compliant

SELF REFRESH
DEEP POWER-DOWN
Figure 17: DEEP POWER-DOWN Command
PDF: 09005aef83d9bee4
1gb_ddr_mobile_sdram_t68m.pdf - Rev. E 12/10 EN
The SELF REFRESH command is used to place the device in self refresh mode; self re-
fresh mode is used to retain data in the memory device while the rest of the system is
powered down. When in self refresh mode, the device retains data without external clock-
ing. The SELF REFRESH command is initiated like an AUTO REFRESH command,
except that CKE is disabled (LOW). After the SELF REFRESH command is registered, all
inputs to the device become “Don’t Care” with the exception of CKE, which must re-
main LOW.
Micron recommends that, prior to self refresh entry and immediately upon self refresh
exit, the user perform a burst auto refresh cycle for the number of refresh rows. Alterna-
tively, if a distributed refresh pattern is used, this pattern should be immediately
resumed upon self refresh exit.
The DEEP POWER-DOWN (DPD) command is used to enter DPD mode, which ach-
ieves maximum power reduction by eliminating the power to the memory array. Data
will not be retained when the device enters DPD mode. The DPD command is the same
as a BURST TERMINATE command with CKE LOW.
BA0, BA1
Address
RAS#
CAS#
WE#
CK#
CKE
CS#
CK
Don’t Care
46
1Gb: x16, x32 Mobile LPDDR SDRAM
Micron Technology, Inc. reserves the right to change products or specifications without notice.
© 2009 Micron Technology, Inc. All rights reserved.
Commands