TMP86C993XB(EYZ) Toshiba, TMP86C993XB(EYZ) Datasheet - Page 212

• Manufacturer Part Number: TMP86C993XB(EYZ)
• Description: EMULATION CHIP FOR TMP86F SSOP
• Manufacturer: Toshiba
• Series: -r

Specifications of TMP86C993XB(EYZ)

• Accessory Type: Adapter
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: TMP86F SSOP
• Other names: TMP86C993XB; TMP86C993XB

19.6
Operation Mode
Note 7: If the security program is enabled or a password error occurs, TMP86FH92DMG stops UART communication and enters
Note 8: If an error occurs during the reception of a password address or a password string, TMP86FH92DMG stops UART com-
Note 9: To rewrite data to Flash memory addresses at which data (including FFH) is already written, make sure to erase the
Description of RAM loader mode
the halt condition. In this case, initialize TMP86FH92DMG by the RESET pin and reactivate the serial PROM mode.
munication and enters the halt condition. In this case, initialize TMP86FH92DMG by the RESET pin and reactivate the
serial PROM mode.
existing data by "sector erase" or "chip erase" before rewriting data.
1. The 1st through 4th bytes of the transmitted and received data contains the same data as in the flash
2. In the 5th byte of the received data contains the RAM loader command data (60H).
3. When the 5th byte of the received data contains the operation command data shown in Table 19-6, the
4. The 7th through m’th bytes of the transmitted and received data contain the same data as in the flash
5. The m’th + 1 through n’th - 2 bytes of the received data contain the binary data in the Intel Hex format.
6. The n’th - 1 and n’th bytes contain the checksum upper and lower bytes. For details on how to calculate
7. After transmitting the checksum to the external controller, the boot program jumps to the RAM address
memory writing mode.
device echoes back the value which is the same data in the 6th byte position (in this case, 60H). If the
5th byte does not contain the operation command data, the device enters the halt condition after sending
3 bytes of operation command error code (63H).
memory writing mode.
No received data is echoed back to the external controller. After receiving the start mark (3AH for “:”)
in the Intel Hex format, the device starts data record reception. Therefore, the received data except 3AH
is ignored until the start mark is received. After receiving the start mark, the device receives the data
record, that consists of data length, address, record type, write data and checksum. The writing data of
the data record is written into RAM specified by address. Since the device starts checksum calculation
after receiving an end record, the external controller should wait for the checksum after sending the
end record. If a receiving error or Intel Hex format error occurs, the device enters the halts condition
without returning an error code to the external controller.
the SUM, refer to "19.8 Checksum (SUM)". The checksum is calculated only when the end record is
detected and no receiving error or Intel Hex format error occurs. After sending the end record, the
external controller judges whether the transmission is completed correctly by receiving the checksum
sent by the device.
that is specified by the first received data record.
Page 198
TMP86FH92DMG