RCLXT16706FE Intel, RCLXT16706FE Datasheet - Page 297

• Manufacturer Part Number: RCLXT16706FE
• Manufacturer: Intel

Specifications of RCLXT16706FE

• Operating Supply Voltage (typ): 3.3V
• Operating Supply Voltage (min): 2.97V
• Operating Supply Voltage (max): 3.63V
• Operating Temp Range: -40C to 85C
• Operating Temperature Classification: Industrial
• Lead Free Status / Rohs Status: Not Compliant

11.9.2
11.10
11.10.1
Datasheet
11:10
15:10
Bit
15
14
13
Bit
9:0
Bit
9:0
12
TPOHINS_Ena
XmtStufCnfg
XmtAuPntrSrc
XmtSetNdf
XmtAuPtSS[1:0]
XmtAuPtVal[9:0]
Unused
XmtCurAuPt[9:0]
T_CAU_PT—Transmit Current AU Pointer Value ((1cc)EAH)
This register provides the current transmit AU Pointer Value. Since Positive and Negative
justification may be set by the microprocessor (register T_AU_PTS), this value might differ from
the programmed XmtAuPtVal[9:0] (register i39H).
SONET/SDH Transmit High-Order Path Termination
Channel Registers
T_HPT_C—Transmit HPT Configuration ((1cc)E8H)
Name
Name
Name
51/155/622/2488 Mbit/s SONET/SDH Cell/Packet Interface — Intel IXF6048
Active high enable for the TPOHINS[cc] hardware insertion control
input pin.
‘0' = disable the transmit POH bytes insertion from the TPOH serial
input bus in channel #(cc). This configuration bit takes precedence
over the TPOHINS hardware control input pin.
‘1' = Enable the transmit POH insertion from the TPOH serial input
bus in channel #(cc). The POH bytes insertion from the TPOH bus
is then controlled by TPOHINS input pin.
In STS-1/STM-0 mode, this bit configures whether the two fixed
stuff columns (#30 and #59) are part of the payload.
'0' = Columns #30 and #59 of the SPE are part of the payload and
their content is part of the B3 BIP calculation.
'1' = Columns #30 and 59 of the SPE are not part of the payload
and considered as stuff columns. (SDH)
This bit forces all AU pointer bytes to be pass-through. It is ignored
in regenerator configuration—the received Pointer bytes are
passed through.
'0' = Internal hardware and microprocessor registers generate the
AU pointer bytes. (SDH)
'1' = All AU pointer bytes are passed through (testing only).
This bit allows the microprocessor to send an NDF. When
writing to this register T_AU_PTS, if XmtSetNdf = '1', then an
NDF ('1001') is inserted in transmit H1.
Bits[1:0] correspond to the transmit SS bits value. For SDH,
set this to ‘10’.
Bits [9:0] correspond to the initial transmit Au pointer value,
set by the microprocessor. A valid pointer value is between 0
and 782, but a value between 783 and 1023 can also be
programmed for default testing.
Bits [9:0] correspond to the current transmit AU pointer
value.
Description
Description
Description
Type
Type
R/W
R/W
R/W
Type
R/W
R/W
R/W
R
Default
Default
Default
00H
00H
'00'
'0'
‘0’
'0'
'0'
297