PEB3265 Infineon Technologies Corporation, PEB3265 Datasheet - Page 198

• Manufacturer Part Number: PEB3265
• Description: (PEB326x / PEB426x) Dual Channel Slicofi-2 / Slic Duslic
• Manufacturer: Infineon Technologies Corporation

Preliminary
Bit
UTDR-EN
UTDX-EN
CIS-AUTO
CIS-EN
Data Sheet
19
H
BCR5
UTDR-
EN
7
Enables the Universal Tone detection in receive direction.
UTDR-EN = 0 Universal Tone detection is disabled.
UTDR-EN = 1 Universal Tone detection is enabled.
Enables the Universal Tone detection in transmit direction.
UTDX-EN = 0 Universal Tone detection is disabled.
UTDX-EN = 1 Universal Tone detection is enabled.
Controls the turn-off behavior of the Caller ID sender.
CIS-AUTO = 0 The Caller ID sender stops when CIS-EN is switched to 0.
CIS-AUTO = 1 The Caller ID sender continues sending data until the
Enables the Caller ID sender in the SLICOFI-2.
Note: The Caller ID sender is configured directly by programming the
CIS-EN = 0
CIS-EN = 1
UTDX-
according POP registers. Caller ID data are written to a 48 byte
RAM buffer. According to the buffer request size this influences the
CIS-REQ and CIS-BUF bits.
EN
6
Basic Configuration Register 5
AUTO
data buffer is empty.
Caller ID sender is disabled and Caller ID data buffer is
cleared after all data are sent or if CIS-AUTO = 0.
Caller ID sender is enabled and Caller ID data can be
written to the data buffer. After the last data bit is sent,
stop bits are sent to the subscriber.
Caller ID data are sent to the subscriber when the number
of bytes written to the buffer exceeds CIS-BRS + 2.
CIS-
5
SLICOFI-2x Command Structure and Programming
CIS-EN
4
198
LEC-
OUT
3
LEC-EN DTMF-
2
00
DuSLIC-E/-E2/-P
H
SRC
1
2000-07-14
DTMF-
EN
0
Y