S9S12G128F0VLL Freescale Semiconductor, S9S12G128F0VLL Datasheet - Page 861

• Manufacturer Part Number: S9S12G128F0VLL
• Description: 16-bit Microcontrollers - MCU 16BIT 128K FLASH
• Manufacturer: Freescale Semiconductor

Specifications of S9S12G128F0VLL

• Rohs: yes
• Core: S12
• Processor Series: MC9S12G
• Data Bus Width: 16 bit
• Maximum Clock Frequency: 1 MHz
• Program Memory Size: 128 KB
• Data Ram Size: 8 KB
• On-chip Adc: Yes
• Operating Supply Voltage: 3.13 V to 5.5 V
• Operating Temperature Range: - 40 C to + 125 C
• Package / Case: LQFP-100
• Mounting Style: SMD/SMT
• A/d Bit Size: 10 bit, 12 bit
• A/d Channels Available: 12
• Interface Type: SPI
• Maximum Operating Temperature: + 125 C
• Minimum Operating Temperature: - 40 C
• Number Of Programmable I/os: 86
• Number Of Timers: 8
• Program Memory Type: Flash
• Supply Voltage - Max: 5.5 V
• Supply Voltage - Min: 3.13 V

Upon clearing CCIF to launch the Read Once command, a Read Once phrase is fetched and stored in the
FCCOB indexed register. The CCIF flag will set after the Read Once operation has completed. Valid
phrase index values for the Read Once command range from 0x0000 to 0x0007. During execution of the
Read Once command, any attempt to read addresses within P-Flash block will return invalid data.
25.4.6.5
The Program P-Flash operation will program a previously erased phrase in the P-Flash memory using an
embedded algorithm.
Upon clearing CCIF to launch the Program P-Flash command, the Memory Controller will program the
data words to the supplied global address and will then proceed to verify the data words read back as
expected. The CCIF flag will set after the Program P-Flash operation has completed.
Freescale Semiconductor
8
Register
FSTAT
Program P-Flash Command
A P-Flash phrase must be in the erased state before being programmed.
Cumulative programming of bits within a Flash phrase is not allowed.
1
CCOBIX[2:0]
Table 25-40. Program P-Flash Command FCCOB Requirements
Global address [2:0] must be 000
MGSTAT1
MGSTAT0
ACCERR
Error Bit
FPVIOL
000
001
010
011
100
101
Table 25-39. Read Once Command Error Handling
MC9S12G Family Reference Manual, Rev.1.23
Set if CCOBIX[2:0] != 001 at command launch
Set if command not available in current mode (see
Set if an invalid phrase index is supplied
None
Set if any errors have been encountered during the read
Set if any non-correctable errors have been encountered during the read
Global address [15:0] of phrase location to be programmed
0x06
CAUTION
Word 0 program value
Word 1 program value
Word 2 program value
Word 3 program value
FCCOB Parameters
Error Condition
Global address [17:16] to
identify P-Flash block
32 KByte Flash Module (S12FTMRG32K1V1)
Table
25-27)
1
863