DF2398F20V Renesas Electronics America, DF2398F20V Datasheet - Page 129

• Manufacturer Part Number: DF2398F20V
• Description: IC H8S/2300 MCU FLASH 128QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2300r

Specifications of DF2398F20V

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 20MHz
• Connectivity: SCI, SmartCard
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 87
• Program Memory Size: 256KB (256K x 8)
• Program Memory Type: FLASH
• Ram Size: 8K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 128-QFP
• For Use With: YR0K42378FC000BA - KIT EVAL FOR H8S/2378
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

5.5
5.5.1
When an interrupt enable bit is cleared to 0 to disable interrupts, the disabling becomes effective after execution of the
instruction.
In other words, when an interrupt enable bit is cleared to 0 by an instruction such as BCLR or MOV, if an interrupt is
generated during execution of the instruction, the interrupt concerned will still be enabled on completion of the instruction,
and so interrupt exception handling for that interrupt will be executed on completion of the instruction. However, if there
is an interrupt request of higher priority than that interrupt, interrupt exception handling will be executed for the higher-
priority interrupt, and the lower-priority interrupt will be ignored.
The same also applies when an interrupt source flag is cleared.
Figure 5-8 shows an example in which the TGIEA bit in the TPU’s TIER0 register is cleared to 0.
The above contention will not occur if an enable bit or interrupt source flag is cleared to 0 while the interrupt is masked.
5.5.2
Instructions that disable interrupts are LDC, ANDC, ORC, and XORC. After any of these instructions is executed, all
interrupts including NMI are disabled and the next instruction is always executed. When the I bit is set by one of these
instructions, the new value becomes valid two states after execution of the instruction ends.
Usage Notes
Contention between Interrupt Generation and Disabling
Instructions that Disable Interrupts
Internal
address bus
Internal
write signal
TGIEA
TGFA
TGI0A
interrupt signal
ø
Figure 5-8 Contention between Interrupt Generation and Disabling
TIER0 write cycle by CPU
TIER0 address
TGI0A exception handling
Rev.6.00 Oct.28.2004 page 99 of 1016
REJ09B0138-0600H